A SERVICE OF

logo

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO15-33001A
(Revision Date: Feb. 25, 2008)
8. RFID Module: B-SA704-RFID-U2-EU-R
8- 5
3. Slightly push the Upper Sensor Lever inside (1), and open the Upper Sensor Ass’y (2).
4. Pushing the tabs on the rear of the Media Sensor Block toward the front of the printer, slightly lift the
back of the Media Sensor Block, and remove it toward the printer back.
5. Turn over the Media Sensor Block, and secure the Antenna Ass’y with the supplied three Tapping
Screws.
Upper Sensor Lever
Upper Sensor Ass’
y
(1)
(2)
Tab
Tab
Media Sensor Block
Tapping Screw M-3x8
Tapping Screw M-3x8
Antenna Ass’
y
Sensor Block