Filter
Top Products
Known Problems 23
you do this, however, the system fails when you attempt to remove one of
the interfaces.
In the following example, the FDDI and the Ethernet interfaces both have
class B IP addresses, and both have the same subnet mask:
FDDI interface
158.101.101.1 Subnet mask: 255.255.0.0
Ethernet interface: 158.101.20.1 Subnet mask: 255.255.0.0
Do not assign different subnet masks to these interfaces (such as
255.255.255.0 and 255.255.0.0) if they have the same class of IP
address.
■ Changing the port speed or port mode before setting a system baseline on
the TRSM might cause incorrect Token Ring port and bridge port statistics.
■ The NVRAM conversion for SNMP traps does not adjust correctly for two
new additions to the trap table. After installing LANplex software revision
8.0.2, verify that the appropriate traps are enabled.
■ Some bridge port statistics are not counted on the TRSM’s Token Ring ports.
The following statistics report 0 in the bridge port display for Token Ring
ports on the TRSM:
■ rxDiscard
■ rxFloodUcasts
■ rxForwardMcasts
■ rxForwardUcasts
■ System does not display the correct hardware revision number for EFSMs.
■ When running large scripts, you might receive the following message after
the script is complete:
Received ftpCommand Quit not completed errno 421
To be sure that the script has completed successfully, check to see that the
last two commands in the script have completed successfully.
■ Performing a manual NVDATA RESTORE causes configurations to be restored
to slots that have been specified not to restore.
When restoring NV data, the system proposes a method of restoration
based on restoration rules. You are prompted to load the proposal. Entering
yes restores the system NV data as proposed. Entering no displays the
saved configuration for you to load manually.