Filter
Top Products
8
LAN
PLEX
® 6000 E
XTENDED
S
WITCHING
S
OFTWARE
Copying System
Software to a
Hard Disk
You can copy system software to a system that has either a UNIX or an
MS-DOS operating system.
Copying to the UNIX® Platform
The LANplex software for a UNIX system is distributed on five diskettes.
Diskettes #1, #2, #3 and #4 contain the LANplex software. Diskette #5
contains the SNMP MIBs.
To copy the software to a UNIX hard disk, follow these instructions.
If the directory “/usr/lp6000R” does not exist on your computer, create the
directory before proceeding. If your “/usr” directory is full, you can use a
different directory. If you use a different directory, substitute the actual
directory used for “/usr” in this and subsequent procedures.
1
Insert diskette #1 containing the system software file into the disk drive.
These instructions assume drive rfd0.
2
Extract the first part of the LANplex software file using the following
commands:
cd /usr/lp6000R
tar xvf /dev/rfd0
3
Remove diskette #1 using the following command:
# eject
4
Insert diskette #2 containing the LANplex software file into the disk drive
and extract the second part of the file using the following command:
tar xvf /dev/rfd0
5
Remove diskette #2 using the following command:
# eject
6
Insert diskette #3 containing the LANplex software file into the disk drive
and extract the third part of the file using the following command:
tar xvf /dev/rfd0
7
Remove diskette #3 using the following command:
# eject