AEG 49332I-MN Cooktop User Manual


 
POWER MANAGEMENT
The power management divides the
power between two cooking zones in a
pair (see the illustration). The Power
function increases the power to the
maximum level for one cooking zone in
the pair and decreases the power in the
second cooking zone. The display for
the reduced zone changes between
two levels.
POWER MANAGEMENT FOR
THE RIGHT COOKING ZONES
AND THE TOP OVEN
The right cooking zones and the
top oven use the same energy
source (the same electrical
phase) when they operate at the
same time. The power manage-
ment prevents a circuit over-
load.
The more power the top oven uses dur-
ing its operation, the less is available
for the right cooking zones. When a
zone cannot use the full power, the dis-
play for the zone changes between the
two levels.
TIMER
Use it to set an automatic switch-off
time for a cooking zone.
1.
Set the cooking zone. Touch
again and again until the indicator
for the necessary cooking zone
comes on.
You must set the cooking zone
before you activate the timer.
2.
Set the heat setting for the cooking
zone. You can also set it after you
activate the timer.
3.
To activate the timer or change the
set time, touch + or - on the hob
control panel. The maximum time
you can set is 99 minutes.
The indicator of the cooking zone
flashes slowly. The timer starts to
count down.
4.
To see the remaining time, touch
again and again until the indica-
tor for the necessary cooking zone
flashes quickly. The display shows
the remaining time.
When the set time ends, 00 flashes
and an acoustic signal sounds. The
cooking zone deactivates.
5.
Touch to stop the signal.
To deactivate the timer before
the set time is completed, set
the cooking zone with
and
touch -. The remaining time
counts down to 00. The indica-
tor of the cooking zone goes
out.
You can use the timer as a Minute
Minder when the cooking zones do not
operate. To do this, set the cooking
zone and activate the timer but do not
set the heat setting.
STOP AND GO
The Stop and Go function sets all
cooking zones that operate to the low-
est heat setting (
).
This function does not deactivate the
timer function.
To activate this function, touch
.
The display shows the symbol
.
12