AEG 49332I-MN Cooktop User Manual


 
do not put any objects directly on
the appliance floor and do not
cover it with aluminium foil;
do not put hot water directly into
the appliance;
do not keep moist dishes and food
in the appliance after you finish the
cooking.
Do not apply pressure on the open
door.
Do not put flammable materials in
the compartment below the oven.
Keep there only heat-resistant acces-
sories (if applicable).
Do not cover oven steam outlets.
They are at the rear side of the top
surface (if applicable).
Do not put anything on the hob that
is liable to melt.
If there is a crack on the surface, dis-
connect the power supply. There is a
risk of electric shock.
Do not put heat-conducting materi-
als (e.g. thin metal mesh or metal-
plated heat conductors) under the
cookware. Excessive heat reflection
can damage the cooking surface.
If you have an implanted pacemaker,
you must keep your upper body a
minimum of 30 cm away from the in-
duction cooking zones while they op-
erate.
Do not use the appliance during a
power cut.
CARE AND CLEANING
Before maintenance, make sure that
the appliance is cold. There is a risk
of burns. There is a risk that the glass
panels can break.
Keep the appliance clean at all times.
A build-up of fats or other foodstuff
can result in a fire.
Regular cleaning prevents the surface
material from deteriorating.
For your personal safety and the
safety of your property, only clean
the appliance with water and soap.
Do not use flammable products or
products that can cause corrosion.
Do not clean the appliance with
steam cleaners, high-pressure clean-
ers, sharp objects, abrasive cleaning
agents, abrasive sponges and stain
removers.
If you use an oven spray, follow the
instructions from the manufacturer.
Do not spray anything on the heating
elements and the thermostat sensor
(if applicable).
Do not clean the glass door with
abrasive cleaning agents or metal
scraper. Heat resistant surface of the
inner glass can break and shatter.
When the door glass panels are dam-
aged they become weak and can
break. You must replace them. Con-
tact the service centre.
Be careful when you remove the door
from the appliance. The door is
heavy.
Bulb lamps used in this appliance are
special lamps selected for household
appliances use only. They cannot be
used for the full or partial illumination
of a household room.
If it becomes necessary to replace
the lamp use one of the same power
and specifically designed for house-
hold appliances only.
Disconnect the appliance from the
power supply before the replace-
ment of the oven lamp. There is the
risk of electrical shock. Cool down
the appliance. There is a risk of
burns.
Do not clean catalytic enamel.
SERVICE CENTRE
Only an approved engineer can re-
pair or work on the appliance. Con-
tact an approved service centre.
Use only original spare parts.
DISPOSAL OF THE APPLIANCE
To prevent the risk of physical injury
or damage:
Disconnect the appliance from the
power supply.
6