Filter
Top Products
33
What to do, when...
Try to rectify minor faults on the dishwasher with the aid of the instructions
given here.
...a flashing fault code appears
an audible signal informs you that an alarm has been activated, in the
display appears one of the following flashing alarms: AL1 - AL2 - AL3 - AL4 -
AL5 - AL6 - AL7 and the indicator light of the phase under way is flashing.
They are indicative of a fault in the dishwasher that you can probably rectify
yourself.
- press the On/Off pushbutton to switch the dishwasher off
- open the door and carry out the following suggested corrective actions.
Fault code
"Water tap" indicator light
flashes and/or alarm AL5
"Open door" indicator light
flashes
Alarm AL6
Alarm AL4
Alarms AL1 - AL2 - AL3 -
AL7 - AL8
The water tap is closed.
The door has not been
properly closed.
Open the water tap.
Close the door.
The mains water supply has
been cut off.
The inlet hose may be
squashed or bent.
The inlet hose may be
blocked.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked.
Protection against flooding
is active.
General
Close the water tap and
contact the Service
Centre.
Open the door, switch off
the dishwasher, switch
back on and start a wash
programme. If the fault
code reappears contact
the Service Centre.
Clear any blockages.
Reposition correctly the
drain hose. Follow the
instructions for
connecting to the waste.
Switch off the water
supply and clean the filter.
Reposition correctly the
hose.
Possible cause Remedy
Once checked the possible causes listed above, switch on the dishwasher and
start a wash programme, if the fault code reappears contact the Service
Centre.
152985 56/1 en-es 30-11-1999 15:04 Pagina 33