Filter
Top Products
38
Installation and connection instructions
Adjusting the worktop
You can move the worktop forward or
backward by 25 mm in order to align the
machine with other kitchen units.
Simply unscrew the two front retaining
screws, move the top to the required
position and then retighten the screws.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you
can install it under a close fitting sink unit
or a pre-existing top, providing the
dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
- Remove the machine’s worktop by
unscrewing the two front retaining
screws, pull from the front and slide out
the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the adjustable
feet. When inserting the machine, ensure that the water inlet and drain
hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the
levelling spacers, either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet
until the machine is perfectly level.
820
570-600
450
IN04
IN02
152985 56/1 en-es 30-11-1999 15:05 Pagina 38