Filter
Top Products
Rev 0.0 13
INSTALLATION INSTRUCTIONS
EN
5 INSTALLATION AND HOOKUP
DURING INSTALLATION, TAKE CARE NOT TO INJURE YOURSELF ON THE
SHARP EDGES OF THE APPLIANCE.
Remove the polystyrene rack blocks. Position the appliance in the chosen instal-
lation position. The sides and rear of the appliance can lie against kitchen units or
walls. If the dishwasher is installed next to a heat source, separate it with a heat
insulating panel in order to prevent overheating and malfunctions. To assure sta-
bility, only install built-in appliances under continuous worktops, securing them
to the adjacent kitchen units or worktop with screws.
BUILDINGIN A DISHWASHER UNDERNEATH A CERAMIC HOB IS ABSO
LUTELY FORBIDDEN. A DISHWASHER CAN BE BUILTIN UNDERNEATH
A CONVENTIONAL HOB PROVIDED THERE IS NO BREAK IN THE KITCH
EN WORKTOP, AND THE DISHWASHER AND HOB ARE INSTALLED AND
SECURED CORRECTLY, SO THAT NO HAZARDS ARE GENERATED.
MAKE SURE THE DISHWASHER HAS BEEN CORRECTLY INSTALLED
AND GROUNDED BY A QUALIFIED FITTER. THIS SAFETY REQUIRE
MENT MUST BE MET. IN CASE OF DOUBT, CALL IN A QUALIFIED FIT
TER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAIL
URE TO GROUND THE APPLIANCE OR FROM A DEFECTIVE GROUND
CONNECTION .
BEFORE PROCEEDING WITH INSTALLATION, DISCONNECT THE
MAINS POWER SUPPLY FROM THE WORK AREA.
Only for free-standing models
It is strictly forbidden to mount a hob over a free-standing dishwasher. •
If the appliance is not in a niche and can therefore be accessed on one side, •
cover the door hinge area for safety reasons (cutting hazard). Covers are avail-
able as accessories from specialized retailers or from the Technical Service Cen-
tre.
To build in the dishwasher, purchase the • relative kit from specialized retailers
or from the Technical Service Centre.