Filter
Top Products
Rev 0.0 17
INSTALLATION INSTRUCTIONS
EN
A through hole with a diameter of at least 8 cm (5/32”) is required to pass the
hoses and power cord (ref. A g. 5-05).
Make sure there area no rough edges that could damage the power cord or hoses.
If the dishwasher is installed in a metal unit protect the edge of the through hole
for the hoses and power cord with a gasket. Do not use extension cords when
making the electrical connection as these do not guarantee safety.
ATTENTION!
INSTALLING THE DISHWASHER IN A NARROW SPACE MAY BEND OR
CRUSH THE POWER CORD. TAKE GREAT CARE IN ORDER TO REDUCE THE
POSSIBILITY OF DAMAGING THE POWER CORD WHEN INSTALLING OR
REMOVING THE APPLIANCE.
A
5.2.1 Connecting to the water supply
PREVENTING THE RISK OF CLOGGING OR DAMAGE: IF THE WATER
PIPE IS NEW OR HAS NOT BEEN USED FOR A LONG TIME, BEFORE CON
NECTING TO THE WATER SUPPLY CHECK THAT THE WATER IS CLEAR
AND FREE OF IMPURITIES, TO PREVENT DAMAGE TO THE APPLIANCE.
THE DISHWASHER MUST ALWAYS BE CONNECTED TO THE WATER
SYSTEM WITH NEW HOSES; OLD OR USED HOSES MUST NEVER BE
REUSED.
Fig. 5-05