Filter
Top Products
INSTALLATION/LEVELLING
The DC6 is designed to stand on a flat and level surface, however, any unevenness may be
overcome by adjusting the four levelling feet, one at each corner of the base plate. The adjusting
screws are accessed by removing left and right hand hotplate castings (See section ‘To Remove
Hotplate Castings - Servicing Section Page 50). To raise the cooker turn screw clockwise, to
lower turn screw anti-clockwise.
There are rollers on the base of the cooker to allow for positioning.
When the cooker is in the correct position the four levelling feet can be adjusted to level the
cooker. THE FEET MUST BE LOWERED ENOUGH TO PREVENT THE COOKER ROLLING
OUT OF POSITION. (See Fig. 5)
12
DESN 512391 BFig. 5
LEVELLING AND MOBILITY WHEELS