Filter
Top Products
ELECTRIC COMBITHERM — INSTALLATION MANUAL #MN-28897
PG. 4
®
COMBITHERM
6•10E
S
SPECIFICATIONS
CA PA CI TY
FULL-SIZE PANS: 20" x 12" x 2-1/2" Six (6)
GN 1/1: 530 x 325 x 65mm Six (6)
HALF-SIZE SHEET PANS:* 18" x 13" x 1" Six (6)
ON WIRE SHELVES ONLY
72 lb (33 kg) MAXIMUM
VOLUME MAXIMUM
: 45 QUARTS (57 LITERS)
WE IGH T
NET 360 lb (163 kg)
SHIP 484 lb (220 kg)
CRATE 40" X 48" X 40" EST.
DIMENSIONS: (1016 x 1219 x 1016mm)
EL EC TR IC AL
VOLTAGE PHASE CYCLE/HZ AWG AMPS kW
at 208 1* 50/60 2 Wire plus ground 40.5 8.4
at 240 AWG 6 47.0 11.2
at 208 3 50/60 3 Wire plus ground 23.5/ph 8.4
at 240 AWG 8 27.0/ph 11.2
at 380 3 50/60 4 Wire plus ground 13.0/ph 8.4
at 415 AWG 12 16.0/ph 11.2
at 440 3* 50/60 3 Wire plus ground 20.0/ph 15.4
at 480 AWG 8 22.0/ph 18.4
* ELECTRICAL SERVICE CHARGE APPLIES
208-240
208-240
380-415
440-480
31-3/8" (796mm)
34-1/16" (864mm)
17-15/16"
(456mm)
7
-9/16"
(191mm)
WATER
D
RAIN
33-1/8" (840mm)
4-15/16"
(125mm)
Steam Vent (Top)
60-9/16" (1538mm)
Water Drain
(Side Back)
T
reated Water
I
ntake (Bottom)
Untreated Water
I
ntake (Bottom)
Electrical Connection
(
Bottom)
30" (761mm)
4-3/4" (120mm)
2
-3/16" (56mm)
(290mm)
6-3/8" (161mm)
41-15/16" (1064mm)
43-7/8" (1114mm)
2
" (50mm)
49-1/8" (1247mm)
15-7/8"
(403mm)
14-3/16"
(360mm)
35-3/16" (893mm)
27-11/16"
(702mm)
7-9/16"
(192mm)
Decalcification
P
ort
11-7/16"
DI ME NS IO NS: H x W x D
EXTERIOR:
35-3/16" x 43-7/8" x 34-1/16" (893mm x 1114mm x 864mm)
EXTERIOR WITH RETRACTABLE DOOR:
35-3/16" x 47-7/8" x 34-1/16" (893mm x 1216mm x 864mm)
INTERIOR:
17-3/4" x 23-1/2" x 21-1/16" (450mm x 597mm x 535mm)
*ADDITIONAL WIRE SHELVES REQUIRED FOR MAXIMUM CAPACITY
IN STA LL ATI ON R EQ UI RE MEN TS
Oven must be installed level.
Hood installation is required.
Water supply shut-off valve and back-flow
preventer.
CL EA RA NC E R EQU IR EM EN TS
LEFT: 6" (152mm) PLUS SERVICE ACCESS: 18" (457mm) RECOMMENDED
20" (508mm) FROM HEAT PRODUCING EQUIPMENT
RIGHT
: 4" (102mm) TOP: 20" (508mm) FOR AIR MOVEMENT
BACK
: 4" (102mm) BOTTOM: 5-1/8" (130mm) FOR LEGS
COUNTER
-TOP INSTALLATIONS MUST MAINTAIN 4" (102mm) MINIMUM
CLEARANCE FROM COUNTER SURFACE
.
WATE R R EQ UIR EME NT S
TWO (2) COLD WATER INLETS - DRINKING QUALITY
ONE (1) TREATED WATER INLET: 3/4" NPT*
ONE (1) UNTREATED WATER INLET: 3/4" NPT*
LINE PRESSURE: 30 to 90 psi 2.8 to 6.2 bar
WATER DRAIN: 1-1/2"
CONNECTION WITH AIR GAP
* Can manifold off of one 3/4" line.
WATE R Q UA LIT Y M IN IM UM STA ND AR DS
USING A WATER SUPPLY NOT MEETING ALTO-SHAAM'S
MINIMUM WATER QUALITY STANDARDS WILL VOID THIS
WARRANTY. It is the responsibility of the purchaser to ensure that
incoming water supply is compliant with the specifications listed
through adequate treatment measures. Installation of the
CombiGuard™ Water Filtration System is recommended, but this
system may not address all water quality issues present.
Contaminant Inlet Water Requirements
(untreated water)
Free Chlorine Less than 0.1 ppm (mg/L)
Hardness Less than 3 gpg (52 ppm)
Chloride Less than 30 ppm (mg/L)
pH 7.0 to 8.5
Alkalinity Less than 50 ppm (mg/L)
Silica Less than 12 ppm (mg/L)
Total Dissolved
Solids (tds) Less than 60 ppm