Filter
Top Products
CONTROL OPERATION
15.
PROG RAMMI NG:
THE OVEN PREHEAT INDICATOR WILL ILLUMINATE.
The oven is now in the preheat mode and is automatically programmed to preheat to the cook temperature.
Select a letter code for the product
programmed by the previous steps.
PRESS AND HOLD THE SELECTED PRESET KEY
UNTIL YOU HEAR A BRIEF, FOUR SECOND BEEP.
• The letter key program indicator
light will illuminate.
• The product programmed is now
stored in memory for the specific
letter key pressed.
• Additional programs can be stored
in the remaining Preset Keys if not
previously programmed.
NOTE: The last Preset Key used will be the
oven cooking run sequence for the next
product to be programmed. Settings
can be manually changed for the next
product and an alternate pre-
programmed letter key can be selected.
IMPORTANT:
After programming a specific product into memory
in a programmable preset key, it is very important to
make a permanent written record of the product and
the program letter assigned. Menu card (PE-23384)
is provided for this purpose.
ERASING A COOKING PROGRAM:
To erase a program no longer used,
or to revise a previously
programmed Preset Key, the oven
must be in either the power-up hold
mode or in the preheat mode. The
oven cannot be running a Preset
Menu program at the time of
cancellation or revision.
When the oven is in the power-up hold mode or in
the preheat mode, press and hold both the Cancel
Key and the appropriate letter Preset Key to be
erased. The oven will beep in approximately four
seconds and the program's indicator light will go out
to indicate the program has been erased.