Amana AOCS3040 Oven User Manual


 
14
Oven Signals
Preheat signal After setting oven to bake and selecting a temperature, oven preheats. When
oven reaches set temperature, 1-second signal sounds.
Timer and
End-of-Cycle signal
When a timed cooking cycle is complete or time elapses on timer, three long signals
sound and then one approximately every 6-8 seconds. End of cycle signal continues
to sound for 5 minutes or until OVEN CANCEL pad is pushed.
If minute timer end of cycle signal is sounding, push TIMER ON/OFF pad.
Other Features
12-hour automatic cancel This safety feature prevents oven from continuing to operate if it has been left on
for over 12 hours. If a cooking function continues longer than 12 hours without any
options on oven control being touched, this feature turns oven off. Any time an
option is touched, 12-hour automatic cancel is reset.
Child lockout
This safety feature is used to prevent children from accidentally programming oven
by disabling electronic oven control. Press and hold BAKE and COOK TIME for 5
seconds. “OFF” displays where the temperature normally appears. To reactivate
control, press and hold BAKE and COOK TIME pads for 5 seconds. Child lockout
must be reset after a power failure.
Service codes and tones Electronic oven control is equipped with a self diagnostic system. Self diagnostic
system alerts you if there is a error or problem in the control. If electronic range
control sounds a series of short, rapid beeps for more than 16 seconds and display
shows a F-code, record the F-code shown. Some F-codes can be cleared by
touching OVEN CANCEL or disconnecting power to the range. If the code continues
to reoccur call an authorized servicer. Disconnect electrical supply to range and
contact an authorized servicer.
F1—Control malfunction
F2—High oven temperature
F3—Temperature sensor malfunction
F4—Temperature sensor malfunction
F7—Touch pad malfunction
F9—Door lock malfunction (Door unlocked)
FF—Door lock malfunction (Door locked)
Sounds
Oven Fan Oven cooling fan can turn on while oven is heating to cool oven control.