Filter
Top Products
14
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
Closes too quickly—
Decrease spring tension
5
If the door falls open, increase the spring tension by moving the
spring end toward the back of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
Door falls open—
Increase spring tension
6
IMPORTANT: If wheels were removed, cover the floor when
moving the dishwasher. Slowly move dishwasher completely into
cabinet opening. Do not kink or pinch water line, drain hose,
power supply cord or direct wire between dishwasher and
cabinet. Remove cardboard from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet opening.
Do not remove insulation blanket – the blanket reduces the
sound level.
NOTE: If using power cord, make sure to route end through hole
in cutout before sliding into cabinet opening.
Move dishwasher into
cabinet opening
7
Insulation
blanket
Insulation
blanket
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your
cabinets.
Align front of dishwasher
with front of cabinet doors
8
9
Check for plumb and
adjust legs if needed
Check that leveling legs are firmly against the floor.
Close and latch the door, and place level against the
front panel. Check that dishwasher is centered from front to back
in the opening. If needed, adjust leveling leg until dishwasher is
plumb. Repeat for other side of dishwasher.
With another person holding the dishwasher to keep it from
tipping, open and close the door a few times. If the door closes
or falls open under its own weight, the door tension will need to
be adjusted.
4
Open and close door