Filter
Top Products
9
Air gap
Large silver drain
hose clamp
(provided)
Drain trap
Air gap
Large silver drain
hose clamp
Drain hose
Drain trap
Rubber hose
connector
Screw-type clamps
Screw-type clampsScrew-type clamps
Waste tee
Waste tee
No waste disposer – with air gap
1. Connect black end of drain hose to air gap
and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach drain hose to air gap with large silver
drain hose clamp (provided).
3. Use pliers to squeeze clamp open and move
into position. If the drain hose was cut, use a
1¹⁄₂” to 2” (3.8 to 5 cm) screw-type clamp
(not provided).
4. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
Air gap
Large silver drain
hose clamp
(provided)
Disposer inlet
Air gap
Large silver drain
hose clamp
Drain hose
Drain trap
Rubber hose
connector
Disposer inlet
Waste disposer – with air gap
Screw-type clampsScrew-type clampsScrew-type clamps
1
2
3
4
5
Black end
1
2
3
Black end
Option C, Waste disposer – with air gap
Option D, No waste disposer – with air gap
Screw-type
clamp
Drain trap
Large silver
drain hose clamp
Drain hose
Drain trap
Waste tee
Waste tee
No waste disposer – no air gap
Waste tee
1. Connect black end of of drain hose to waste
tee and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach black end of drain hose to waste tee
with a large silver drain hose clamp (provided).
Use pliers to squeeze clamp open and move
into position. If the drain hose was cut use a
1¹⁄₂” to 2” (3.8 to 5 cm) screw-type clamp (not
provided).
1
2
Black end
Option B, No waste disposer – no air gap
1. Using a hammer and screwdriver, knock
plug into disposer.
2. Use needle nose pliers to remove plug.
3. Connect black end of drain hose to air gap
and cut if needed.
NOTE: Do not cut ribbed section.
4. Attach drain hose to air gap with large
silver drain hose clamp (provided). Use
pliers to squeeze clamp open and move
into position. If the drain hose was cut, use
a 1¹⁄₂” to 2” (3.8 to 5 cm) screw-type clamp
(not provided).
5. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.