Filter
Top Products
AP20BC175-2 Manual
14
PROGRAMMING
1. INITIAL PROGRAMMING
NOTE: Initial programming is preset at the factory. Use this section only if changes are
desired. If no changes are to be made, skip to Page 17 ( 2. Programming the cycles ).
a. With the display reading "OFF", press
("START/STOP") for a few seconds.
b. To change the language, press or then
press
.
ENGLISH
Blinks
c. Enter the default password by pressing, in order, the
and buttons.
If the entered password is wrong the display will show,
for 3 seconds:
Then the controller will go back to step c.
TRY AGAIN
Blinks
NOTE: If a wrong password is introduced three times the controller will go into “OFF” state.
OFF
INITIAL PROGRAMMING
SELECT LANGUAGE
ENGLISH
INITIAL PROGRAMMING
ENTER PASSWORD:
***
During the password typing,
button can be used to delete one or more characters.
d. If you do not wish to change the password, press
.
To change the default password, press
or
for "YES" then press
.
The password will always be a combination of three of the six available cycles:
("SOFT", "HARD", "SHOCK", "DEF", "UV", "HEAT PROBE").
Type the new password, then press
.
Be sure to remember the new password and keep a record of it in a safe place.
e. To change the year, press or then press
.
2006(year)
Blinks
f. To change the month, press or then
press
.
07(month)
Blinks
INITIAL PROGRAMMING
WRONG PASSWORD
TRY AGAIN
INITIAL PROGRAMMING
CHANGE PASSWORD?
NO
INITIAL PROGRAMMING
SET YEAR
2006
INITIAL PROGRAMMING
SET MONTH
07