Anetsberger Brothers MX-7A Fryer User Manual


 
22
FRFR
FRFR
FR
YER YER
YER YER
YER
TRTR
TRTR
TR
OUBLESHOOOUBLESHOO
OUBLESHOOOUBLESHOO
OUBLESHOO
TING GUIDE TING GUIDE
TING GUIDE TING GUIDE
TING GUIDE
(Continued)
PROBLEM CAUSE REMEDY
Liquid shortening does
not reach the desired
temperature for frying.
1. Low gas supply pressure [less than 6 W.C.
for natural gas; (11 W.C. for propane)
when
all other gas-powered equipment is
operating], causing reduced heat from main
burners.
2. Low gas manifold pressure [less than 3½
W.C. for natural gas; (10 W.C. for pro-
pane)].
3. Loose knob on thermostat;
or thermostat
requires calibration (temperature setting dif-
fers by about 10°F from measured shorten-
ing temperature).
1. Measure the gas supply pres-
sure.
Contact your local gas supplier
to obtain adequate gas supply
pressure.
2. Measure the gas pressure at
the fryer’s manifold pressure
tap. Adjust the manifold pres-
sure (see Figure 6), as neces-
sary: [a] Unscrew (and re-
tain) the threaded Main Burner
Regulator Adjustment Cover.
Use a flat-blade screwdriver to
turn the regulator adjustment
screw (clockwise to increase;
counterclockwise to decrease)
to reset the pressure adjust-
ment. Reinstall, and tighten,
the Regulator Adjustment
Cover, when finished.
3. Stir the shortening to mix the
hot shortening with some from
the lower ‘cool zone’ and allow
it to sit for 5 minutes. Turn the
thermostat knob until it ‘clicks’
on (causing the main burners to
flame); note the setting where
this occurs. Turn the thermo-
stat until it ‘clicks’ off (causing
the main burners to go out);
note the setting where this
occurs. Repeat this tempera-
ture ‘click points’ step at least
three times to ensure that
the shortening temperature has
stabilized.
Measure the temperature of
the shortening by inserting an
accurate thermometer about
4 inches into the shortening to
measure its temperature. If the
temperature variation between
the measured temperature and
the thermostat setting is 10°F
or less, the thermostat can be
recalibrated.