Filter
Top Products
Connect gas hob to gas supply
The inlet is at the rear RHS of the hob.
The hob may be connected to the gas
supply either by rigid pipework or flex-
ible connection.
Flexible connections
Use a 900mm - 1125mm length of
flexible connector. Ensure that the
hose is installed hanging freely down-
wards, is not trapped, is not subjected
to undue forces and is not supported
at the bottom by a horizontal surface.
Natural Gas - Flexible connections
should comply with BS669, latest edi-
tion.
LP Gas - For flexible connections use
a bayonet type hose, suitable for use
on LP gas up to 50 mbar pressure rise
and 70˚C temperature rise. The flexi-
ble hose should be coloured black
with a red stripe, band or label. If in
doubt, contact your supplier.
The installation must ensure that the
flexible tube cannot come into contact
with movable parts of the housing unit
(eg; a drawer) and does not pass
through any space susceptible to becoming
congested.
Make sure the appliance is gas
sound & all components are
operating correctly.
Connect to the electricity supply
Unless this appliance is supplied with a
fitted plug, it must be connected by a
competent person, using fixed wiring
via a double pole switched fused spur
outlet, with a contact separation of 3mm
at all poles.
Connect the mains lead wires to the
terminals:
The blue wire must be connected to the
terminal marked N (Neutral)
L
OAD
or
coloured black. The brown wire must
be connected to the terminal marked L
(Live) LOAD or coloured red.
The green/yellow coloured wire must
be connected to the terminal marked
E (Earth) or coloured green.
Warning: this appliance must be
earthed.
The fused spur must be accessible after
installation.
If the supply cord is damaged, obtain
a special cord from the Customer Care
Helpline, which must be fitted by a
qualified person.
18