Glen Dimplex Home Appliances Ltd 70T Cooktop User Manual


 
Be safe - not sorry
Caution: When you are cook-
ing, keep children away from the
vicinity of the hob.
Parts of the appliance may be hot
during or immediately after use.
Allow sufficient time for the hob to
cool after switching off.
Never use the appliance for
heating a room.
Turn pan handles to a safe posi-
tion, so they are out of reach of chil-
dren, not overhanging the appli-
ance, and cannot be caught
accidentally.
Position pans over the centre of the
burners / hotplates. If positioned
off centre, smaller pans may be
unstable.
Keep all flammable materials (such
as curtains, clothing & furnishings)
away from the hob.
Do not let pans overhang the con-
trol knobs, as this may overheat
and damage them.
Never leave fat or oil unattended on
a lit hob.
Caution: Where this appliance
is installed in a boat or cara-
van, it shall not be used as a
space heater.
Check that all controls are in
the off position when you have
finished cooking.
Ignition
Auto ignition (if fitted):
Push in and hold down the control
knob, and turn to the full on position
(large flame symbol). Keep the knob
depressed after the burner has lit for
up to 15 seconds to allow the flame to
establish. Turn the control knob to the
desired setting.
Manual ignition (if fitted):
Push in & hold down the control knob
turning to the full on position (large
flame symbol) & press the ignition but-
ton until the gas lights. Keep the con-
trol knob depressed after the burner
has lit for up to 15 seconds to allow
the flame to establish. Turn the control
knob to the desired setting.
In the event of the burner flames being
accidentally extinguished, turn off the
burner control and do not attempt to
re-ignite the burner for at least 1
minute.
Reduced rate
Turn the control knob to the small
flame symbol.
To switch off
To switch off a hob burner, turn the
control knob clockwise to the “off”
position.
If the ignition fails
1.Make sure all the controls are in the
“off” position, and check there is a
spark at the back of the burner when
you depress the control knob or press
the ignition button.
2.Gas check - check there is gas to the
appliance by lighting a burner with a
lighted match.
3.Electrical check-if no spark renew
the 3 ampfuse in the fused spur.
4.Check burner caps are fitted cor-
rectly
6