Filter
Top Products
Belling Installation Instructions
Prepare installation
Do not lift the oven by the door
handle.
Whilst every care is taken to eliminate
burrs and raw edges from this
product, please take care when
handling - we recommend the use of
protective gloves during installation.
Please note that the weight of this
appliance is approximately 47kg
(unpacked). Take care when lifting it
into the housing unit - always use an
appropriate method of lifting.
Please note that all dimensions and
sizes given are nominal - some variation
is to be expected.
If the appliance is to be installed near
to a corner where the adjacent
cabinets run at right angles forward of
the appliance, there must be a gap of
at least 90mm between the appliance
and the cabinets, to prevent
overheating of the cabinets.
1. Remove the fixing screws from the
polythene bag on the top of the
appliance, but leave the appliance
in the base tray packaging until
you are ready to install it.
Note: When removing the appliance
from the base tray packaging care
should be taken to ensure the outer
frame trim is not damaged.
2. (i) When installed in a typical
600mm deep built in housing
unit, the false back should be
removed from the housing
unit, to provide the necessary
depth for installation.
(ii) When the false back is
removed, it is normally the
case that the support shelf for
the appliance leaves a gap
between the back edge and the
wall of approximately 80mm.
(iii) If no gap occurs between the
back edge of the shelf and
the wall behind the unit, we
recommend that a gap of at
least 30mm is made by
shortening the shelf.
34