Filter
Top Products
Installation
6
Oven Assembly
DOOR RELOCATION
The KCO-25E is shipped with the door hinged on
the right side. If left hand operation is necessary
use the following procedure to relocate the door.
1. Shut off the oven power switch.
2. Remove the door as follows:
a.) Loosen the two upper door bolts.
b.) Loose n the two lower door bolts. Remove
the top bolt.
c.) Slide th e remaining lowe r door bolt up in
its slotted hole.
NOTE: The lower door pin a ttac hed to the
bolt will release from the bushing
in the unit frame.
d.) Tilt the door (with the 5/16” thick was her)
away from the unit.
e.) Lower the door so tha t th e upper door pin
drops out of the bushing in the unit frame.
3. Relocat e the hinge and catch parts as follows:
a.) Remove the trim plates located on the
frame opposite the door pins. The two
plates are attached with one screw each.
NOTE: This will expose the pin/bushing
holes for the alternate door loca-
tion.
b.) Move the tw o bras s door bushings in the
unit frame to the alternate door pin/bush-
ing holes .
c.) Attach the trim plates to the frame over the
two holes w h ere the bushings were.
Mounting holes are provided at the new
locati ons.
NOTE: N ote that the upper trim pl ate has
a slotted air opening.
d.) Move the door catch plate located on the
upper door frame to the opposite side of
the oven cavity. Mounting holes are pro-
vided at the new location for the catch
plate (two screws).
4. Reattach the door as follows:
a.) Attach the door to the unit at the relocated
bushings by reversing the steps above.
b.) Tight en th e four door bolts hand tight only.
5. Relocate the handle and plate assembly on
the door as follows:
a.) Remove the four hex head screws which
attach the handle plates to the door.
b.) Twist the upper plate around the door
handle by at least 90_.
c.) Lowerthehandleandplateassemblyout
of the door.
d.) Flip the ha ndle and plate ass embly 18 0_.
e.) Reattach the assembly by inserting the
roller latch plate into the opening at the
door top.
f.) Twistthelowerplatearoundthedoorhan-
dle to its orig inal mounting position .
g.) Reinstall the four screws through the han -
dle plate into the door.
6. Adju st the door as follows:
a.) Clos e the door and check that the roller
latch secures the door tightly.
b.) Adjust the catch plate (by its slotted
mounting holes) if necessary.
7. Turn the unit on and verify that the door prox-
imity switch shuts o ff the fan when the door
opens .
Han dle & Plat e
Assembly
Door Bolt
Trim Plate
Door Catch
Unde r Over hand
Figure 4