Filter
Top Products
GAS AND ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
SECTION ONE: GENERAL SAFETY INSTRUCTIONS
SAFETY
SAVE THESE INSTRUCTIONS
It is the personal responsibility and obligation of you, the user, to have this
appliance connected to the electrical power supply in accordance with the
National Electrical Code and/or applicable local codes and ordinances by a
qualified electrician.
See Installation Instructions for electrical requirements and ground-
ing instructions.
ALWAYS DISCONNECT THE
ELECTRICAL PLUG FROM THE
WALL RECEPTACLE BEFORE
SERVICING THIS UNIT.
It is recommended that a dedicated
circuit servicing this appliance be
provided.
The use of gas cooking appliances
results in the production of heat and
moisture.
Gas Models:
PGR304
120 volts, 60 Hz.,
10 Amp electrical circuit required.
Gas Models:
PGR364GD, PGR364GL,
PGR366
120 volts, 60 Hz.,
10 Amp electrical circuit required.
Gas Models:
PGR486GD, PGR486GL,
PGR484GG
120 volts, 60 Hz.,
10 Amp electrical circuit required.
PLEASE READ CAREFULLY
If for any reason a gas control knob is turned ON and there is no electrical
power to operate the electronic igniters on the cooktop burners, turn
OFF the gas control knob and wait 5 minutes for the gas to
dissipate before lighting the cooktop burner manually.
To light the cooktop burners manually, carefully hold a lighted match to
the burner ports and turn the gas control knob to HI. During a power
failure you can use the cooktop burners, but each must be lit with a
match.
DO NOT attempt to light the two left burners manually. These burners
are equipped with the ExtraLow
®
feature and cannot be lit manually.
CAUTION - ALL MODELS
IN CASE OF AN ELECTRICAL FAILURE
FOR PERSONAL SAFETY,
THIS APPLIANCE MUST
BE CONNECTED TO A
PROPERLY GROUNDED
AND POLARIZED ELEC-
TRICAL POWER SUPPLY.
Page 3
TESTED IN ACCORDANCE
WITH:
• ANSI Z21.1-2000 for House-
hold Gas Appliances
• UL858 14th Edition for House-
hold Gas Ranges
• CAN/CSA-22.2 No. 61-M89 for
Household Cooking Ranges
• CAN/CGA 1.1-M81 Domestic
Gas Ranges
Check your local building codes
for the proper method of installa-
tion. In the absence of local codes,
this unit should be installed in ac-
cordance with the National Fuel
Gas Code No. Z223.1 Current
Issue and the National Electrical
Code ANSI/NFPA No. 70 Current
Issue or the Can - B149 Installation
Codes for Gas Burning Appliances
and C22.1 Canadian Electrical
Code Part 1.
Accessible parts may become
hot when the grill is in use.
Young children must be kept
away.
CAUTION