Filter
Top Products
23
Cleaning after use
1. Ensure the power cord is unplugged
and the Speed Control Dial is in the
'OFF' position.
2. If the pouring shield is assembled,
detach the pour spout then slide the
main ring from the mixing bowl.
3. Press the 'Tilt-Release' button and
simultaneously use the Lift Assist
Handle to raise the mixer head until it
locks into the open position.
4. Remove the attachment from the
Attachment Shaft then remove the
mixing bowl from the Bowl Locking
Recess (see page 13, 14 and 15 for
detailed instructions).
5. Wash the mixing bowl, pouring shield,
spatula, scraper beater, flat beater, wire
whip and dough hook in warm soapy
water with a soft cloth. Rinse and dry
thoroughly. Alternatively, the mixing
bowl, pouring shield, spatula and
attachments may be washed in
the dishwasher (spatula and
attachments, top shelf only).
NOTE:
Do not use abrasive scouring pads
or commercial cleaners when
cleaning the mixing bowl, pouring
shield, spatula, scraper beater, flat
beater, wire whip or dough hook as
these may scratch the surface. Also
ensure that the attachments are
not soaked in water for extended
periods of time, for example several
hours or overnight, as this may
damage their finish.
6. Wipe the mixer head, Attachment Shaft
and mixer base with a soft, damp cloth
then dry thoroughly. Wipe any excess
food particles from the power cord.
CARE & CLEANING
NOTE:
Do not wash or immerse the mixer
head and mixer base in water or any
other liquid. Clean with a soft, damp
cloth and dry thoroughly. Do not
allow water or any liquid to enter the
gear system as damage may result.
Storage
1. The Mixer should be kept in a
convenient position on your kitchen
bench top or in an accessible
cupboard.
2. Ensure the power cord is unplugged
and the Speed Control Dial is in the
'OFF' position.
3. Insert the mixing bowl into the Bowl
Locking Recess and securely lock into
place.
4. Place the attachments inside the
mixing bowl.
5. Press the 'Tilt-Release' button and
simultaneously use the Lift Assist
Handle to lower the mixer head until it
locks into the closed position.
6. Slide the main ring of the pouring shield
into position on top of the mixing bowl
then attach the pour spout.
7. The mixer head cannot be taken off the
mixer base for any purpose.
BEM800XL_IB_v10.indd 23 19/11/09 3:16 PM