Filter
Top Products
20 21
OPERATING YOUR BREVILLE PRODUCT
ADVANCED ESPRESSO FUNCTIONS
Press & Hold - 1 CUP
Press & hold 1 CUP to bypass the
pre-infusion phase and deliver water to
the group head at the full 9 bar pressure.
Release button to stop extraction. This
function can be used when purging the
group head.
Press & Hold - 2 CUP
Press & hold 2 CUP to bypass the
pre-infusion phase and deliver water to
the group head at the full 9 bar pressure.
Release button to stop extraction. This
function can be used when purging
the group head.
Press & Hold - MANUAL
Press & hold the MANUAL button to
deliver water to the group head at low
pre-infusion pressure. When MANUAL
button is released, water will continue at
the full 9 Bars of pressure. Press MANUAL
button again to stop extraction .
This function can be used to manually
control the pre-infusion duration.
ADVANCED MENU
To access the Advanced Menu:
With machine OFF, press and hold the
1 CUP button, then press the POWER
button.
POWER
POWER
TURN
POWER OFF
THEN PRESS
& HOLD
Resetting default settings
The machine has the following
default settings:
1. Temperature – 93°C
2. Pre-Infusion – Duration Pr07
3. Pre-Infusion – Power PP60
4. Steam temperature - 135°C
5. Machine Audio - LO
6. CLEAN ME! alert - OFF
7. Auto Start - OFF
8. Auto Start Time - 7.00am
9. Audio - LO
10. Water Hardness - 3
11. Espresso Volume durations –
30/30 secs
To reset machine to original default settings,
first enter Advanced Menu. RESt will be
displayed on the LCD. Press the MENU
button to reset the machine to the default
settings. The machine will beep 3 times
to confirm.
The machine will then prompt you to set the
water hardness. Select your water hardness
using the UP & DOWN arrows & press
MENU to confirm or press EXIT to return
to STANDBY mode.
OPERATING YOUR BREVILLE PRODUCT
Descale (dESc)
Use this function to access the step by step
de-scale procedure.
Step 1 – Prepare for De-scale
a) Turn Machine off and allow to cool
for 1 hour.
b) Remove portafilter and set aside.
c) With the machine OFF, press &
hold the 1 CUP button, then press
the POWER button.
d) Press the UP arrow to select ‘dESc’.
e) Press the MENU button to enter
De-scale Mode.
f) The LCD screen will display ‘PUSH’.
The MANUAL button LED will
illuminate. Do not push the MANUAL
button at this stage.
g) Empty water tank, remove water
filter then fill water tank with de-
scale solution, as per manufacturer’s
instructions. Fill tank to max line with
water and replace.
h) Ensure drip tray is empty and installed
into position. Place cloth on right side of
the drip tray to stop steam escaping.
NOTE
Machine will exit and start up without
saving if no operation for 30 seconds
or user presses the EXIT button.
Step 2 – Empty Boilers
a) Remove grey silicon cover on the right
hand lower side of the front panel
marked DESCALE ACCESS.
REMOVE
b) Using a flat-head screwdriver, rotate the
left screw counter-clockwise first, until
valve is fully open. Water will begin to
flow into drip tray from underneath.
c) Do the same for the right screw.
Steam will be released from the boiler.
CAUTION HOT STEAM!
CAUTION HOT STEAM!
d) Close valves when water stops flowing
through both outlets. Empty drip tray
and re-assemble onto unit.
CAUTION HOT WATER!
e) Press MANUAL button, to proceed to
next step.