Filter
Top Products
32 33
CARE & CLEANING CARE & CLEANING
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The filter baskets and portafilter should
be rinsed under hot water directly after
use to remove all residual coffee oils.
If the holes in the filter baskets become
blocked, dissolve a cleaning tablet in
hot water and soak filter basket and
portafilter in solution for approx. 20
minutes. Rinse thoroughly.
CLEANING THE SHOWER SCREEN
• The group head interior and shower
screen should be wiped with a damp cloth
to remove any ground coffee particles.
• Periodically run hot water through the
machine with the filter basket and
portafilter in place, without ground
coffee, to rinse out any residual coffee.
CLEAR WATER BACK-FLUSH
• Insert the cleaning disc into the 1 cup
filter basket.
• Insert portafilter into the group head.
• Press the 1 CUP button to build pressure
in the basket.
• Repeat several times to remove residual
coffee oils in the espresso water paths.
CLEANING THE DRIP
& STORAGE TRAY
• The drip tray should be removed,
emptied and cleaned after each use or
when the drip tray indicator is showing
Empty Me!
• Remove grill from the drip tray. Wash
the drip tray in warm soapy water.
The Empty Me! indicator can also be
removed from the drip tray.
• The storage tray can be removed and
cleaned with a soft, damp cloth (do not
use abrasive cleansers, pads or cloths
which can scratch the surface).
CLEANING THE OUTER HOUSING
& CUP WARMING TRAY
• The outer housing and cup warming tray
can be cleaned with a soft, damp cloth.
Polish with a soft, dry cloth. Do not use
abrasive cleaners, pads or cloths which
can scratch the surface.
NOTE
Do not clean any of the parts or
accessories in the dishwasher.
DESCALING THE BOILERS
Access the advance menu, refer to page 20.
Select the descale option.
Descale (dESc)
Use this function to access the step by step
de-scale procedure.
Step 1 – Prepare for De-scale
a) Turn Machine off and allow to cool
for 1 hour.
b) With the machine OFF, press &
hold the 1 CUP button, then press the
POWER button.
c) Press the UP arrow to select ‘dESc’.
d) Press the MENU button to enter
De-scale Mode.
e) The LCD screen will display ‘PUSH’.
Power button and MANUAL button
LEDs will be on.
f) Empty water tank, remove water
filter then fill water tank with de-
scale solution, as per manufacturer’s
instructions. Fill tank to max line with
water and replace.
g) Ensure drip tray is empty and installed
into position. Place cloth on right side of
the drip tray to stop steam escaping.
NOTE
Machine will exit and start up without
saving if no operation for 30 seconds
or user presses the EXIT button.
Step 2 – Empty Boilers
a) Remove grey silicon cover on the right
hand lower side of the front panel
marked DESCALE ACCESS.
REMOVE
b) Using a flat-head screwdriver, rotate the
left screw counter-clockwise first, until
valve is fully open. Water will begin to
flow into drip tray from underneath.
c) Do the same for the right screw.
Steam will be released from the boiler.
CAUTION HOT STEAM!
CAUTION HOT STEAM!
d) Close valves when water stops flowing
through both outlets. Empty drip tray
and re-assemble onto unit.
CAUTION HOT WATER!
e) Press MANUAL button, to proceed to
next step.