Filter
Top Products
34 35
Step 3 – Begin De-scale
NOTE
If water tank has not been removed
then replaced or is empty, water tank
LED will flash 5 times and the machine
will beep 3 times and "Fill Tank" will
be displayed in the LCD.
NOTE
If boilers are not empty, the machine
will beep 3 times and the downlights
will flash 5 times and "VALV" will be
displayed in the LCD.
a) Machine will fill boilers with de-scale
solution and heat to temperature.
b) 20 minute timer will begin. Countdown
timer is finished when PUSH is
displayed on the LCD screen.
(This allows solution to dissolve
scale build up).
Step 4 – Empty De-scale Solution
a) Empty water tank, rinse and fill water
tank with clean water. Replace tank
into machine.
b) Ensure drip tray is empty and installed
into position. Place cloth on right side of
the drip tray to stop steam escaping.
c) Rotate left screw first, counter-clockwise
until fully open. Water will begin to flow
into drip tray.
d) Repeat with right screw. Steam
will be released from the boiler.
CAUTION HOT STEAM!
CAUTION HOT STEAM!
e) Close valves when water stops
flowing through both outlets. Empty
drip tray and re-assemble onto unit.
CAUTION HOT WATER!
CARE & CLEANING CARE & CLEANING
Step 5 – Fill Boilers
Press MANUAL button and the 5 minute
timer will begin. Countdown timer is
finished when PUSH is displayed on the
LCD screen.
(This allows any remaining solution
to be removed from system).
Step 6 – Flush Boilers
a) Empty water tank, rinse and assemble
new water filter into tank.
b) Fill water tank with clean water and
replace into machine.
c) Rotate screws counter-clockwise, as per
previous instructions until fully open.
Water will begin to flow into drip tray.
d) Close valves when water stops flowing
through both outlets. Empty drip tray
and re-assemble onto unit. CAUTION
HOT WATER!
e) Press MANUAL button to complete the
de-scale procedure. Machine will heat
up as normal.