Filter
Top Products
30 31
PAge heAder.....
CARE & CLEANING
CARE & CLEANING
CLEANING CYCLE
• CLEAN ME! will be displayed on
LCD to indicate when a cleaning cycle
is required (approx. 200 shots).
• Insert the supplied cleaning disc,
followed by 1 cleaning tablet into the
1 CUP filter basket.
• Insert the portafilter and lock into
group head.
• Ensure the water tank is filled with cold
tap water.
• Ensure the drip tray is empty & inserted.
• Press MENU button until
CLEAN CYCLE icon flashes and
PUSH is displayed on the LCD screen.
• To start the Clean Cycle press the
illuminated MANUAL button.
• The CLEAN CYCLE icon will flash and
the machine will start to countdown
from 370 seconds.
• When the cleaning cycle has finished,
remove the portafilter and ensure
the tablet has completely dissolved.
If the tablet has not dissolved, repeat
the steps above, without inserting a
new tablet.
• Rinse the filter basket and portafilter
thoroughly before use.
INSTALLING WATER FILTERS
• Soak filter in a glass of water for
5 minutes.
• Rinse the filter and mesh under
running water.
• Assemble filter into filter holder.
• Set replacement date forward 2 months.
• Install filter holder into water tank.
• Insert water tank into the machine.
Ensure the latch is locked into position.
NOTE
To purchase filters contact Breville
Customer Service Centre
AUS 1300 139 798 NZ 0800 273 845
or visit www.breville.com.au
NOTE
Change filters every 2 months.
Contact Breville Customer Service
Centre for advice.
CLEANING THE STEAM WAND
• Wipe the steam wand with a damp cloth
& purge directly after texturing the milk.
• If the any of the holes in the tip of the
steam wand become blocked, ensure
the STEAM LEVER is in the CLOSED
position and clean using the pin on the
end of the cleaning tool.
• If steam wand remains blocked, remove
the tip using the integrated spanner in
the cleaning tool and soak in hot water.
Screw tip back onto the steam wand
using the integrated spanner in the
cleaning tool.