Filter
Top Products
18 19
PAGE HEADER..... PAGE HEADER.....
OPERATING YOUR BREVILLE PRODUCT
Steam Temperature (StEA)
Adjust Steam Temperature to control the
pressure of the steam being delivered.
Lower steam temperature to texture smaller
volumes of milk or have more control. Raise
steam temperature to texture larger volumes
of milk.
Press MENU to Select STEAM.
Use UP and DOWN arrows to select
required steam temperature.
Press MENU to set.
Machine will beep once to confirm selection.
Machine Audio (Snd)
Machine Audio refers to the volume level
of the ‘beeps’ heard.
• HI - high volume
• LO - low volume
• OFF - volume off
Press the MENU button to select Audio.
Press UP or DOWN arrows to select
desired volume. Press MENU to set.
Machine will beep once to confirm selection.
Volumetric Control (vOL)
Use this function to set Duration or Volume
to control the espresso output.
Press the MENU button to select. Use the
UP or DOWN arrows to select FLo or SEc.
Press MENU to set. Machine will beep once
to confirm selection.
ADJUSTING PRE-INFUSION
Pre-Infusion Programming
With machine in STANDBY mode, press
UP and DOWN arrows together to enter
Pre-Infusion programming mode.
Press MENU button to move between
Pre-infusion Duration and Power.
Pre-Infusion Duration
The LCD will display the current
Pre-Infusion Duration.
Press UP or DOWN arrow to vary time.
We recommend a range of between
5 - 15secs as being optimum.
OPERATING YOUR BREVILLE PRODUCT
Pre-Infusion Power
The LCD will display current
Pre-Infusion Power.
Press UP or DOWN arrows to vary power.
We recommend a range of between
55–65 as being optimum. Press EXIT to
confirm setting and return to STANDBY
mode.
ALERTS
STEAM LED Flashing At START UP
The machine will not enter START UP mode
when the STEAM LEVER is in the OPEN
position and the STEAM LED is flashing.
Move the STEAM LEVER to the
CLOSED position for the machine to
enter START UP mode.
HOT WATER LED Flashing At START UP
The machine will not enter START UP
mode when the HOT WATER dial is in the
OPEN position and the HOT WATER LED
is flashing.
Move the HOT WATER dial to the
CLOSED position for the machine to
enter START UP mode.
HOT WATER LED Flashing
The HOT WATER LED will flash when
the HOT WATER function has been
operating for longer than 1 minute.
Move the HOT WATER dial to
CLOSED position for machine to
enter STANDBY mode.
FILL TANK
The machine will detect a low water level.
The FILL TANK icon will be displayed on
the LCD screen.
If FILL TANK icon is displayed, add
water to tank until machine returns to
STANDBY mode.
CLEAN ME!
The machine will detect when 200
extractions have been carried out
since the last clean cycle.
The CLEAN ME! icon will be displayed
on the LCD screen the next time the
machine enters START UP mode.
For information on how to clean the
machine, refer to the CLEAN CYCLE
instructions on page 23.