Filter
Top Products
26 27
3 – Begin Descale
Press MANUAL button to proceed.
Machine will fill boilers with descale solution
and heat to temperature. During this time,
water may flow through the group head. Wait
for countdown timer to reach 0. This allows
solution to dissolve scale build-up.
NOTE
If boilers are not empty, the machine
will beep 3 times, 'vALv' will display
on the LCD and the 1 Cup button is
illuminated. Ensure the left screw of
the descale valve is fully open and
then Press the 1 Cup button.
4 – Empty Descale Solution
a) Empty water tank then rinse and fill
with clean water to the MAX line. Replace
and lock water tank back into position at
the back of the machine.
b) Place a cloth over the drip tray to stop
steam escaping.
c) Repeat steps 2b) - d)
d) Press MANUAL button to proceed.
NOTE
If boilers are not empty, the machine will
beep 3 times, ‘vALv’ will display on the
LCD and the 1 Cup button is illuminated.
Ensure the left screw of the descale valve
is fully open and then Press the 1 Cup
button.
5 – Fill Boilers
During this procedure, the LCD
will display below.
The 5 minute timer will begin. During this
time, water may flow through the group head.
Wait for countdown timer to reach 0. This
allows any remaining solution to be removed
from system.
6 – Flush Boilers
a) Empty and rinse water tank. Assemble new
water filter into tank.
b) Fill water tank with cold water to MAX
line. Replace and lock water tank back into
position at the back of the machine.
c) Ensure drip tray is empty and fully inserted
into position.
d) Place a cloth over the drip tray to stop
steam escaping.
e) Repeat steps 2b) - d)
f) Press MANUAL button to complete
descale procedure. Machine will heat
up and is ready to use once operating
temperature (STANDBY mode)
is reached.
NOTE
If boilers are not empty, the machine
will beep 3 times, ‘vALv’ will display
on the LCD and the 1 Cup button is
illuminated. Ensure the left screw of
the descale valve is fully open and
then Press the 1 Cup button.
CARE & CLEANING TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES WHAT TO DO
The Hot Water LED
flashes when the machine
is turned On
• Hot Water dial is open. Turn the Hot Water dial to
the CLOSED position.
The Steam LED flashes
when the machine is
turned On
• Steam Lever is open. Move the Steam Lever to
the CLOSED position.
Water does not flow from
the group head
• Machine has not
reached operating
temperature.
Allow time for the machine
to reach operating
temperature. The POWER
light will stop flashing
when machine is ready.
• Water tank is empty. Fill Tank.
• Water tank not fully
inserted & locked.
Push water tank in fully
and close the latch.
FILL TANK displayed
on LCD, but water tank
is full
• Water tank is not fully
inserted and locked
into position.
Push water tank in fully
and close the latch.
No Steam or Hot Water • Machine is not turned
on.
Ensure the machine is
plugged in, switched On
at the power outlet and the
POWER button is On.
No Hot Water • Water tank is empty. Fill water tank.
No Steam • Steam Wand is blocked. Use the pin on the cleaning
tool to clear the holes. If
the steam wand continues
to be blocked remove the
tip of the steam wand using
the spanner in the cleaning
tool and soak in hot water.