Filter
Top Products
24 25
CARE & CLEANING
CLEANING THE FILTER BASKETS AND
PORTAFILTER
• The filter baskets and portafilter should be
rinsed under hot water directly after use to
remove all residual coffee oils.
If the holes in the filter baskets become
blocked, dissolve a cleaning tablet in hot
water and soak filter basket and portafilter
in solution for approx. 20 minutes. Rinse
thoroughly.
CLEANING THE SHOWER SCREEN
• The group head interior and shower screen
should be wiped with a damp cloth to
remove any ground coffee particles.
• Periodically run hot water through the
machine with the filter basket and
portafilter in place, without ground coffee,
to rinse out any residual coffee.
CLEAR WATER BACK-FLUSH
• Insert the cleaning disc into the 1 cup filter
basket.
• Insert portafilter into the group head.
• Press the 1 CUP button to build pressure in
the basket.
• Repeat several times to remove residual
coffee oils in the espresso water paths.
CLEANING THE DRIP
& STORAGE TRAY
• The drip tray should be removed, emptied
and cleaned after each use or when the drip
tray indicator is showing Empty Me!
• Remove grill from the drip tray. Wash the
drip tray in warm soapy water. The Empty
Me! indicator can also be removed from the
drip tray.
• The storage tray can be removed and
cleaned with a soft, damp cloth (do not use
abrasive cleaners, pads or cloths
which can scratch the surface).
CLEANING THE OUTER HOUSING
& CUP WARMING TRAY
• The outer housing and cup warming tray
can be cleaned with a soft, damp cloth.
Polish with a soft, dry cloth. Do not use
abrasive cleaners, pads or cloths which can
scratch the surface.
NOTE
Do not clean any of the parts or
accessories in the dishwasher.
DESCALE (dESC)
Use this function to access descale procedures
as displayed on the LCD. Please ensure you
allow approximately 1 hour to complete the
entire descale process and follow the step by
step instructions promptly.
1 – Prepare for Descale
a) Empty the drip tray and insert into
position.
b) Turn the machine off and allow to cool
for at least 1 hour. With the machine
off, press and hold the 1 CUP button,
then press and hold the POWER button
together for 3 seconds. rEST will appear on
the LCD.
CARE & CLEANING
c) Press UP or DOWN arrow to set mode, the
‘dESC’ will appear on the LCD.
d) Press the MENU button to enter Descale
mode. The LCD will display ‘PUSH’.
Power button and MANUAL button will
illuminate. Do not push any buttons at this
stage.
2 – Empty Boilers
a) Remove the grey silicone cover on the
lower front panel marked DESCALE
ACCESS. Place a cloth over the drip tray
to stop steam escaping.
REMOVE
b) Use a flat-head screwdriver to rotate the
right screw counter-clockwise until the
valve is fully open. As the valve opens,
steam may be released.
When the water is completely empty, close
the valve by rotating screws clock-wise
until seated. Do not overtighten screws to
avoid damages to the valves.
c) Next, repeat the above process on the left
screw. As the valve is opened, water may
begin flowing into the drip tray. When the
water is completely empty, close the valve
by rotating screws clock-wise until seated.
Do not overtighten screws to avoid
damages to the valves.
d) Empty the drip tray. Use caution as the drip
tray may be hot due to the water and steam
released from the boilers.
e) Empty water tank, remove water filter.
f) Place descale solution into water tank,
fill with cold water to MAX line, (if an
alternative cleaning solution is used, please
follow the manufacturer’s instructions
accordingly). Lock water tank back into
position at the back of the machine.
NOTE
If water tank has not been removed,
replaced or is empty, water tank LED
will flash 5 times, the machine will
beep 3 times and 'FILL TANK' will be
displayed on the LCD.
NOTE
If boilers are not empty, the machine will
beep 3 times, 'vALv' will display on the
LCD and the 1 Cup button is illuminated.
Ensure the left screw of the descale valve
is fully open and then Press the 1 Cup
button.