Filter
Top Products
13
PAGE HEADER.....
OPERATING YOUR BREVILLE JUICE FOUNTAIN™ MULTI-SPEED
1. Wash selection of fruit and vegetables to
be juiced.
NOTE
Most fruit and vegetables such as
apples, carrots and cucumbers will not
need to be cut or trimmed to size as
these will fit whole into the feed chute.
Ensure vegetables such as beets,
carrots, etc. have all soil removed, are
well washed and trimmed of leaves
before juicing.
2. Ensure the juicer is correctly assembled.
Refer to Assembling your juicer. Ensure
the juice jug (or a glass) is placed under
the spout and the pulp container is in
position before commencing juicing.
3. Plug the power cord into a 110/120V
power outlet. The LCD display
will illuminate.
4. Press the ON/OFF switch on the control
panel to ON. The juicer will start to
operate at the selected speed. The speed
can be changed at any time during the
juicing process by adjusting the variable
speed control dial.
5. With the motor running, place food into
the feed chute and use the food pusher
to gently guide food down. To extract the
maximum amount of juice, always push
the food pusher down slowly.
6. As fruit and vegetables are processed,
juice will flow into the juice jug and the
separated pulp will accumulate in the
pulp container. The pulp container can
be emptied during juicing by turning the
juicer OFF at the control panel and then
carefully removing the pulp container.
Replace the empty pulp container into
position before continuing to juice.
NOTE
After 3 minutes, the LCD display will
automatically turn off if the ON/OFF
switch is not turned ON, or a speed is
not selected.
NOTE
The LCD display will illuminate
continuously for 3 minutes before going
into a sleep mode, where it will turn off
automatically to conserve power.
The screen will come back on after
activating the ON/OFF switch, the
speed control dial, or the safety
locking arm.
When the safety locking arm is not
locked into place on top of the juicer
cover, the LCD display will illuminate
and flash with an “L”, indicating that
the safety locking arm should be
locked into place.
When the safety locking arm is locked
into place on top of the juicer cover,
the LCD display will illuminate and
display the selected speed setting. The
speed can be changed by adjusting the
variable speed control dial. For a quick
juicing speed reference, use the speed
guide displayed on the LCD screen,
the speed selector table located on the
pulp container, or refer to the speed
selector table.
Hard fruits and vegetables will put
excess strain onto the motor if a low
speed is selected. Please refer to the
speed selector table to determine
the correct speed for the fruits and
vegetables being juiced