Filter
Top Products
10
“AUTOMATIC SECTION”
INITIAL BREWER SET-UP
1. Remove the lid and
water reservoir.
(CAUTION: Do not place the brewer in
a sink or other water source.)
7. Place a mug or bowl that
will hold at least 414 ml
(14 fl. oz.) onto the drip
tray grate.
3. Replace the reservoir
and lid and close the
slide lid.
8. Press and release
the coffee brew
button to fill the
reservoir with
water.*
4. To ensure the Pod Holder
is locked in place, use
thumb to press the
pod holder release
button to eject the
holder and then press
all the way in to lock.
(CAUTION: Water may not immediately flow
from the brewer. Never remove pod holder
from brewer during a brew cycle.)
(CAUTION: You should hear a clicking sound
when the pod holder locks in place.)
5. Slide the volume
control lever to the
maximum setting.
6. Plug in the brewer
and turn on the
power switch.
11. Press and release
the coffee brew
button a third
time.*
(CAUTION: Water should flow from the pod
holder. Wait until water drip out has finished
before removing the pod holder.)
P2961
P2903
P2958
P2965
P2958
P2959
P0214/2960
10. Empty any water in the mug or bowl and
place the mug back on the drip tray grate.
2. Thoroughly rinse the water reservoir.
9. Press and release
the coffee brew
button again to fill
the internal water
tank.*
P2958
For pour-over set-up, go to “Pour-Over Section” on page 12.
You are now finished preparing the brewer
for it’s first use. Proceed to the “Brewing
Delicious Coffee Or Tea” section.
* Some noise is normal when the water
pump is running.
(NOTE: Wait for Heating Indicator to go out
before proceeding to Step #11)
P3017