Bunn MCAA Coffeemaker User Manual


 
7
DEFINITIONS
COMPONENTS
WATER RESERVOIR - Holds reserve water for brewing. The reservoir can be removed
and filled separately at a sink or other clean water source or by pouring water through the
slide lid. (Holds 1.7 L (46 oz.) to the maximum line.)
SLIDE LID - The slide lid allows access to the reservoir. Water can be poured through the
opened lid and into the reservoir without removing the reservoir.
POD HOLDER RELEASE BUTTON - Push to unlock and release the pod holder. When
there is power to the brewer, this button will illuminate red in color, showing the
trademark BUNN name. This light will go out during a brew cycle and when the brewer
has gone into Sleep Mode. (Refer to the “Features” section on page 8 for more
information.)
BLUE (BREW) LIGHTS - Blue colored lights are located near the pod holder area and light
up to indicate that a brew cycle is in process.
SPRAYHEAD SEAL - The seal keeps water under pressure from escaping, while a brew
cycle is in process. If leaks are present during a brew cycle, consult the
“Troubleshooting”
section on page 18.
SPRAYHEAD - Designed to distribute water evenly across the coffee pod or tea bag/pod
to extract the proper flavor.
POD HOLDER INSERT - A color-coded, removable screen designed to allow proper flow
rates and steeping capabilities for the type of brew desired.
POD HOLDER - Holds the coffee pod or tea bag/pod.
DRIP TRAY GRATE - A removable part that allows any spilled liquid to drip through into
the drip tray.
DRIP TRAY - Removable tray that is designed to catch any spilled liquid.
POWER SWITCH - Turns on and off all electrical service to the brewer. This button is
only to be used when the brewer will not be used for several days. (In the “I” position the
power is on. In the “O” position the power is off.)
WATER INLET - This fitting allows a quick connect to existing water lines to allow a constant
supply of water to the brewer.
VOLUME CONTROL SLIDE LEVER - Adjusts the amount of water dispensed through the
pod holder. Sliding it left will produce a smaller serving. Sliding it to the right will produce
a larger serving. The brewer will dispense approximately 118 to 355 ml (4 to 12 oz.) in 30
ml (1 oz.) increments.
CONTROL PANEL - Controls for brewing coffee or tea and various indicators are located
on the control panel. (FIG. 2) See specific definitions below.
CONTROL PANEL
COFFEE BREW BUTTON - Depress this button to brew a serving of coffee. Pressing it again
will cancel a brew cycle in process.
REFILL WATER INDICATOR - If the water in the reservoir is running low, and either the
Coffee or Tea Brew button is pressed, this indicator will flash for a few seconds to show that
the water reservoir needs to be refilled. A brew cycle cannot be started until the reservoir
has been refilled.