Filter
Top Products
5
• Use CAUTION when dispensing hot water from the brewer. The water from your BUNN
®
Pod brewer is approximately 93°C (200°F). This is approximately 10°C (50°F) hotter
than the hot water from your faucet and must be handled with care.
• This brewer is designed to remain plugged in at all times (except during initial installation,
cleaning, or when brewer will not be used for an extended period of time).
• A power switch is provided on the lower left side to completely shut off all electrical
components when your plans take you away from the brewer for three or more days.
Safety features, designed into the BUNN
®
Pod brewer, make the daily use of this switch
unnecessary.
• Whenever the brewer has been shut off or unplugged for an extended period of time, rinse
the reservoir and refill with fresh cold water before using. It is also recommended that the
brewer be cycled. (See page 17)
• Your BUNN
®
Pod brewer has a specially designed tank to keep the water inside at the
proper temperature. This constant supply of hot water assures the correct method of
brewing in less than one minute.
• When inserting a pod into the pod holder, it is important to seat the pod all the way into the
holder cavity. Leaks could occur if the pod is too large, or does not seat completely into
the holder cavity. Ensure that all of the paper edge and any tabs of the pod are inserted
into the holder cavity.
• While brewing, the newest water in the tank is also being heated to the proper temperature
and held until needed.
• International brewers are equipped with a 230 volt, grounded cord set. The plug is
provided with a grounding circuit in compliance with local requirements. This is a safety
feature and allows the plug to fit into a properly grounded outlet. If the plug does not fit
into the outlet, contact an electrician to update your outlet. Attempting to bypass the
safety aspect of this plug will void the warranty.
• The sprayhead may become loose over time. Unplug the machine and allow it to cool
down before tightening or removing the sprayhead. Use extreme caution not to burn
yourself. Tighten or remove the sprayhead with your fingertips. (Refer to page 16)
• CAUTION: Never apply force to remove the pod holder. If the holder does not slide out
easily, wait 10 minutes and try again. Burns resulting from hot water splash could occur if
the holder is forcibly removed from the brewer.
• Use
CAUTION to avoid burns during consumption of any freshly brewed beverage.
Servings are extremely hot.
• To stop a brew cycle in process, press the Coffee or Tea button again. (See “Brew Cancel”
on Page 8)
• When operating the brewer on a standard household outlet, do not attempt to power other
appliances on the same circuit. Circuit overload could occur.
• Some noise is normal when the water pump is running during a brew cycle.
GENERAL INFORMATION
Improper installation could result in permanent damage and void the
limited warranty. Read & follow instructions on page 9 or 10.