Filter
Top Products
16
8) When the cycle has finished, empty the container. Repeat step 7 at least two more
times to remove the solution from the tank.
9) Clean the pod holder with a mild detergent and rinse thoroughly.
10) Proceed to the “Cleaning The Sprayhead/Seal” section.
CLEANING THE SPRAYHEAD/SEAL
1) Press the Power Switch into the off “O” position.
2) Unplug the brewer and allow it to cool down. (Minimum of 1 hour.)
3) After the unit has been allowed to cool, remove the pod holder and set aside.
4) Using your fingers, rotate the sprayhead/seal assembly
clockwise until the sprayhead and seal are removed.
NOTE: If the sprayhead and seal are separated, they must be
reassembled as they were when removed from the brewer.
CAUTION: Improper reassembly could result in personal injury
from scalding water.
NOTE: See “Assembling Sprayhead/Seal” (Page 16) & “Inspecting
Sprayhead Seal” (Page 17) for more information.
5) Clean the sprayhead and seal with a mild detergent and rinse
thoroughly.
6) Using your fingers, rotate the sprayhead/seal assembly counter-clockwise until it is
finger tight.
7) Replace the pod holder.
8) Plug in the brewer and press the Power Switch to restore power to the brewer.
ASSEMBLING THE SPRAYHEAD/SEAL
If the sprayhead and seal are separated during removal or cleaning, they must be
reassembled properly.
1) Identify the top of the seal. The top of the seal that seats
against the roof of the sprayhead ramp has a rough ridge that
can be felt by running your fingers across the surface of the
seal. The bottom is smooth.
2) Identify the top of the sprayhead. The top of the sprayhead
has a star pattern and a threaded hole where the sprayhead
attaches to the brewer.
3) While carefully stretching the seal, guide the sprayhead into
the channel of the seal. Make sure it is completely in the
channel.
When properly assembled, the sprayhead will slide easily into
the channel of the seal and will not cause any buckles in the surface
of the seal. If the sprayhead seems to be difficult
to seat, and you
must stretch the seal more than a slight tug, the assembly is not
together correctly.
CAUTION: Improper reassembly could result in personal injury
from scalding water.
Top
Top
P2953
P2953
P2953
PERIODIC CLEANING/DESCALING (Cont.)
P3015