Filter
Top Products
Extremely Hot Coffee:
If you like your coffee even hotter you can inject steam. This will
make the crema disappear.
• Slip on the Dual Frother Plus (Fig. 18)
• Push the Steam button (Fig. 3). The display shows
HEATING.
After a few seconds the display shows READY.
• Immerse the tip of the Dual Frother into your cup of coffee and
push the Steam button again. Hot steam is injected.
• Push any button to stop the steam injection.
CAUTION: If you steam the coffee too long it will begin to boil
and possibly splash from your cup.
Coffee with Milk:
If you normally add cold milk to your coffee we recommend to
pre-warm your milk. Proceed as follows:
• First add cold milk to your pre-warmed cup.
• Use the Dual Frother to steam the milk (Fig. 18, 19, 20)
• Push the Steam button:
HEATING. It will take a few seconds
for the system to be ready for steam.
• When the display shows READY, immerse the tip of the Dual
Frother into the milk and push the Steam Button. STEAM. Let
the hot steam warm up the milk for a few seconds.
• Then push the steam button again, to stop.
• Now place the cup under the coffee spouts and add your coffee.
11. BREWING COFFEE AND ESPRESSO
(1 ESPRESSO, 2 ESPRESSI, 1 COFFEE, 2 COFFEES)
• Place one or two cups underneath Dual Coffee Spouts and
push the desired button.
The Impressa J5 will grind, tamp and then brew the coffee. It
uses a 2-step brewing process (Pre-Brew Aroma System).
First, it moistens the ground coffee (pre-brew phase), pauses
for a few seconds, and then starts the brewing process. The
display will show the name of the button you pushed, e.g.
1 ESPRESSO and then the strength, e.g. STRONG and then
1 ESPRESSO again. The brewing process stops automatically
as soon as the programmed volume of coffee is produced.
Very Important: After the brewing stops, the J5 will discard the
used coffee. Please do not pull out the drawer (Fig. 1.11)
during this time. It can seriously damage the machine. There
is no need to pull out the drawer unless you see the message
EMPTY GROUNDS, see chapter 21.
When the display shows READY you can brew the next cup of
coffee.
Please note: You can always stop the brewing process by
pushing the Rotary Dial or any of the beverage buttons.
This will not affect the programmed values.
11.1 OVERRIDING STRENGTH AND CUP SIZE DURING
BREWING.
With the J5’s override feature you are always able to change
certain settings just before brewing without affecting the pre-set
values. This is a great feature if you desire a different kind of
coffee which is not programmed. (For changing programmed
values see chapter 17.2).
• For the two single-cup coffee buttons you can override the
strength and the coffee volume.
• For the two double-cup coffee buttons you can override the
coffee volume (those two buttons will always brew in the
XSTRONG setting).
15.