Filter
Top Products
Your machine is too cold. The heating sensor does not react.
Turn the machine off. Keep the machine at normal room
temperature (65º F or higher) for 2 hours. Then turn it on again.
If the display still shows
ERROR 2 or ERROR 4 call customer
service.
ERROR 6, ERROR 7
Turn machine off, turn the main power switch off and unplug
machine for a minute. Turn machine on again. If the error
message comes up again, try one more time. If the message
persists, call customer service.
ERROR 8
Reasons:
1. The used coffee release mechanism got stuck.
2. Drawer was pulled out of the machine during operation.
3. The inner screen of the brew-unit needs to be wiped off.
Solution 1: Turn machine off (Fig. 2). Remove the complete
drawer. Wait for five minutes. Turn the machine on and wait until
a message appears. Insert the complete drawer.
Solution 2:
• Turn machine off (Fig. 2).
• Remove the complete drawer and wait 10 minutes for the
machine to cool down.
• Reach inside the opening. Reach up, behind the movable flap.
Your fingers will touch a round metal surface. You can feel that
there is a screw in the middle of this surface. This is the inner
screen.
• Take a paper towel and wipe this screen. Replace the
complete drawer.
• Turn the machine on. First use the hot water cycle, then try to
make a cup of coffee. If the message
ERROR 8 still persists
call customer service.
24. REMOVING STONES FROM THE BURR GRINDER
Occasionally small stones can be found in between coffee
beans. They can block the burr grinder. The grinding noise will
become loud and no coffee will be ground.
• Turn off the machine by pushing the ON/OFF button (Fig. 2).
• Wait until the machine has shut down completely.
• Turn the main power switch off (Fig 1a).
• Open the bean container lid and remove the bean aroma lid.
• Loosen the screw in the bean container (Fig. 28) and lift the
finger protection.
• Remove the beans.
• Attach the burr grinder release tool (this tool is located in the
Welcome Box) to the upper burr (Fig. 30). If you cannot find
this tool call 1-800-220-5701 and we will send the tool to you
free of charge.
• Turn the tool slowly counter-clockwise until the stone becomes
loose and remove the stone.
Attention: Do not try to turn the tool clockwise.
Close the finger protection and tighten the screw.
Turn machine on and test the grinder without beans to see if
the blockage has disappeared.
25. SUPPLIES
The following supplies are necessary to keep your machine in
good working order. You can purchase these supplies:
• from your local Jura-Capresso retailer,
34.