Filter
Top Products
short coffee and discard. The next cup will taste a lot better.
• Always pre-warm your cup with hot water (chapter 10).
• Keep the coffee spouts as close as possible to the cups to
maximize crema.
20.1 AUTOMATED CLEANING PROGRAMS
The J5 has four automated programs. When it’s time the display
will remind you to perform those programs.
• Rinsing the machine (e.g. chapter 8)
• Changing the Clearyl filter (chapter 15.2.)
• Cleaning the machine; tablet cleaning cycle to remove coffee
oil build-up (chapter 18.1)
• Descaling the machine (chapter 18.3).
20.2 CLEANING THE BEAN CONTAINER
Coffee oils might build up inside the bean container. These oils
might reduce the taste of your coffee. Too much oil might also
hinder the beans from flowing freely into the grinder. Clean the
bean container from time to time.
When the display shows
FILL BEANS, the container is low on
beans and easy to clean.
• Turn off the machine by pushing the ON/OFF button (Fig. 2).
• Wait until the machine has shut down completely.
• Turn the main power switch off (Fig 1a).
• Open the bean container lid and remove the bean aroma lid.
• Loosen the screw in the bean container (Fig. 28) and lift the
finger protection.
• Remove the remaining beans.
• Clean the bean container with a soft, dry cloth.
• Close the finger protection and tighten the screw and fill with
beans.
20.3 CLEANING METAL CONTACTS / TRAY MISSING
If you insert the drawer correctly and the display still shows
TRAY MISSING, remove the drawer and clean and dry the two
metal contacts at the end of the drawer. Then insert again.
20.4 CLEANING THE INSIDE OF THE MACHINE
• Turn off the machine by pushing the ON/OFF button (Fig. 2).
• Wait until the machine has shut down completely.
• Let cool down for 10 minutes.
• Remove the complete drawer. Wipe the inside of the machine
with a paper towel.
• Reach inside the opening and up behind the movable flap .
Feel for a round metal surface. You can feel that there is a
screw in the middle of this surface. This is the inner screen.
• Take a paper towel and wipe this screen.
• Replace the complete drawer (Fig. 1, parts 8, 9, 10, 11)
• Turn the machine on again with the On/Off button (Fig. 2).
20.5 CLEANING THE FROTHXPRESS AND DUAL FROTHER
See chapters 12.1.5, 12.1.6 and 12.2.1.
21 DISPLAY MESSAGES
EMPTY TRAY
.
The drawer is full with water. Remove complete drawer and
empty all parts.
EMPTY GROUNDS.
Remove complete drawer and empty all parts.
TRAY MISSING.
The drawer is not inserted or not inserted correctly. Insert drawer
correctly. Clean and dry metal contacts at the end of drawer.
31.