Filter
Top Products
17.1 OPTIONAL CLEANING CYCLES
The J5 has built-in maintenance programs which automatically
remind you when it is time to perform them. You can also
choose to perform these programs outside the programmed
cycles. This comes handy if you have not used the machine for
a long time or for reasons mentioned below.
To access these maintenance programs outside the built-in
cycles, proceed as follows:
READY
• Push and hold the Rotary Dial until the display shows RINSE.
• Push the Rotary Dial, the display shows RINSE. Turn the dial
and the display will show the following options: CLEAN,
DESCALE, EXIT, RINSE,
Please note: If you do not take action at that time, the display
will go back automatically to READY.
Please note: If the Clearyl Filter is activated, the above
sequence will read
RINSE, CLEAN, FILTER, EXIT.
Example for an additional RINSE cycle:
• Place a cup underneath the coffee spouts. READY.
• Push and hold the Rotary Dial until the display shows
RINSE.
• Push the Rotary Dial, the display shows RINSE. Push the
rotary dial again. RINSING. The machine will run a 15 second
hot water rinse cycle and return to READY.
Example for an additional Tablet Cleaning Cycle:
See chapter 18.2.
17.2 RE-PROGRAMMING ALL BEVERAGE BUTTONS
All six beverage buttons have factory settings (chapter 5).
You can override certain settings for just one cup (see chapter
11.1). Overriding does not change the programmed setting for
the next use.
24.
DISPLAY
LANGUAGE
EXIT
You can choose the volume display in metric
(ML = milliliters) or in non-metric (OZ = ounces);
you can also choose the time format for TIME
on UNIT-ON in AM/PM or 24 HRS (military time).
Change the display from English to French,
Italian, Dutch (NL) or German.
Push the Rotary button. This brings you back
to READY to make coffee again.
17.8
17.9
HARDNESS
ENERGY
TIME
UNIT-ON
OFF AFTER
INFO
Set the water hardness level to the water you
are using. The machine will then automatically
remind you when it’s time to de-scale the
machine. If the CLEARYL water filter is
installed, this program will not show up.
You can choose an energy savings mode. The
machine will lower the temperature in stand by.
Set the time. Once the time is set, you can
program an auto-on time (see UNIT-ON).
If the actual time is set, you can program an
AUTO-ON time
The machine is set to turn off after 2 hours after
last use. You can change this to other intervals.
You can check how many cups of coffee you
made, total and by beverage button. You can
also check the number of tablet cleaning cycles,
decalcifying cycles, and Clearyl filters used.
16.1
17.3
17.4
17.5
17.6
17.7
Display Function/Comment Chapter