Filter
Top Products
IMPORTANT: do not use carbonated water or any other liquid in
the water tank.
You have the following options to take care of the water.
• Clearyl Water Filter Cartridge (chapter 15).
• Decalcifying System (chapter 18.3).
Your machine is pre-set in the factory to automatically remind
you to decalcify based on a water hardness of Level 2. You can
change the water hardness setting to comply with the water you
are using (chapter 16.1).
Please note: The machine will automatically remind you when it
is necessary to run certain water maintenance programs. It is
important that you follow those instructions. Otherwise your
machine may not function properly.
15. CLEARYL WATER FILTER CARTRIDGE
The machine comes with one Clearyl Water Filter Cartridge.
To reorder cartridges, see chapter 25.
The Clearyl cartridge
• transforms your tap water into pH-neutral water and reduces
water hardness up to 75%,
• cleans the water through an upward current principle (Fig. 22)
just before the brewing cycle starts, ensuring freshly filtered
water every time you make coffee,
• removes (if present) up to 85% chlorine, up to 90% lead, up to
95% copper and up to 67% aluminum,
• contains only pure organic materials (ion exchangers and
active carbon) with no chemical additives,
• preserves fluorides and minerals,
• eliminates decalcifying except when using extremely hard
water (25 grains or higher), see chapter 16. In this case we
recommended to decalcify the machine once or twice a year.
15.1 INSTALLING AND ACTIVATING THE CLEARYL FILTER
Important: Never install the cartridge before or during
"Preparing Machine For The First Time" (chapter 6).
READY
1. Push and hold the Rotary Dial until the display shows RINSE.
2. Turn the Dial clockwise until the display shows FILTER –.
3. Push the Rotary dial. The display shows
NO –.
4. Turn the dial until YES appears and push the dial again. OK.
5. The display shows alternating INSERT RINSE and the rinse
button illuminates.
6. Remove the Clearyl cartridge from its bag and rinse cartridge
under water.
7. Add the extension rod to the cartridge (Fig. 23).
8. Remove the water tank, make sure it is empty.
9. Pull up the cartridge holder and insert the cartridge with its
tapered end down into the water container (Fig. 24, 25, 26).
10. Make sure it fits securely inside the fins. Push down gently
(Fig. 25).
11. Close the cartridge holder. Make sure the holder snaps into
place.
12. Fill the water tank with fresh cold water and replace.
13. Place a 20 oz. container under the steam nozzle (Fig. 18).
14. Press the rinse button.
FILTER RINSING.
15. Approx. 16 oz of cold water is pushed through the filter and
through the frother. The rinsing water might be slightly
discolored. This is not harmful and does not affect the taste
of your next coffee. The rinsing stops automatically.
HEATING. READY.
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.
21.