Filter
Top Products
Least expensive: Decalcifying System (chapter 18.2, 18.3).
Your machine is pre-set in the factory to automatically remind
you to decalcify based on a water hardness of Level 2. You can
change the water hardness setting to comply with the water you
are using (chapter 15a).
Please note: The machine will automatically remind you when it
is necessary to run certain water maintenance programs. It is
important that you follow those instructions. Otherwise your
machine might break down.
14. CLEARYL WATER FILTER CARTRIDGE
The machine comes with one Clearyl Water Filter Cartridge. The
Clearyl cartridge
• Reduces the water hardness up to 75%.
• Removes (if present) up to 85% chlorine, up to 90% lead, up
to 95% copper and up to 67% aluminum.
• Cleans the water through an upward current principle (Fig. 9)
just before the brewing cycle starts, ensuring freshly filtered
water every time you make coffee.
• Eliminates decalcifying except when using very hard water
(25 grains or higher), see chapter 15. In this case we recom-
mended to decalcify the machine once or twice a year.
• To reorder cartridges, see chapter 21.
14a. INSTALLING & ACTIVATING THE CLEARYL WATER
CARTRIDGE
Installing:
Important:
Never install the cartridge before or during
"Preparing Machine For The First Time" (chapter 6).
• Remove cartridge from its bag and rinse cartridge under water.
• Add the extension rod to the cartridge (Fig. 11).
• Remove the water tank, make sure it is empty.
• Pull up the cartridge holder and insert the cartridge with its
tapered end down into the water container (Fig. 12, Fig. 13).
Make sure it fits securely inside the fins. Push down gently
(Fig. 13).
• Close the cartridge holder. Make sure the holder snaps into
place.
• Fill the water tank with fresh cold water and replace.
Activating:
You must activate the cartridge otherwise the machine cannot
monitor it properly and assumes that the machine is still in
decalcifying mode.
SELECT PRODUCT
1.Push the Rotary Dial until you hear a beep. The display shows
FILTER NO
2.Push the Rotary Dial again, to enter the FILTER function.
3.Turn the Rotary Dial until the display shows FILTER YES and
push the Rotary Dial to confirm. The display shows
INSERT
FILTER/PRESS STEAM.
4.Place a 20 oz. container under the Steam Nozzle (Fig. 4) and
push either steam button (Fig. 3, K or M). The display shows
FILTER RINSING. For the next 60 seconds the machine will
push water through the cartridge and out through the steam
nozzle. Initially, the water may have a slight discoloration. The
program will stop automatically. The display shows
SELECT
PRODUCT
.
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.
18.