Filter
Top Products
Clearyl Cartridge. If the cartridge is in use for several weeks install
a new cartridge.
Important: The decalcifying program must not be interrupted.
DECALCIFYING AGENT: Only use our special decalcifying
tablets Model # 61848, see chapter 21.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
CAUTION: Immediately remove any splashes or drops of the
decalcifying solution from sensitive surfaces, such as natural
stone or wood.
Always wait until the decalcifying solution in the water tank has
been used up. Do not fill additional decalcifying solution into the
water tank.
18.3 DECALCIFYING PROCEDURE
SELECT PRODUCT/DE-SCALE MACHINE
1. Push and hold the Rinse button until the following message
appears EMPTY TRAY/EMPTY GROUNDS.
2. Remove and empty the tray and the used coffee container
and replace
TRAY MISSING.
Attention: If the tray and the used coffee container are
empty, you need to remove the tray for approx. 20 seconds
and then replace it.
AGENT IN TANK/PRESS STEAM
3. Empty the Water Container. Remove the Dual Frother.
4. Dissolve 3 of the large square decalcifying tablets in a con-
tainer with 20 oz. of water (0.6 liters) and pour the solution
into the water tank. Replace water tank.
5. Place a large container under the steam nozzle (Fig. 4).
6. Push either steam button. The display shows
MACHINE
DE-SCALING. The lights in the Steam buttons start blinking.
The machine will pump the mixture in intervals through the
steam nozzle into the container underneath. After 10 minutes
the machine "beeps". The display shows
OPEN TAP.
7. Empty the container underneath the steam nozzle and
place it underneath the hot water spout (Fig.1,14).
8. Turn the Selector switch to the hot water position (Fig. 3,L).
The machine will now pump the mixture in intervals through
the hot water spout.
MACHINE DE-SCALING.
9. After approximately six minutes the machine will beep
again. The display shows
CLOSE TAP. Turn the
selector switch (Fig. 3,L) back to the cup symbol MACHINE
DE-SCALING
. The machine will now pump the remaining
mixture in intervals into the used water tray inside. After
another 12 minutes the machine "beeps" and the display
shows EMPTY TRAY/EMPTY GROUNDS.
10. Carefully remove the used water tray (Fig. 1,18 ),
TRAY
MISSING empty it, rinse thoroughly and replace. The display
shows FILL WATER TANK/RINSE WATER TANK.
11. Remove the water tank, rinse thoroughly, fill it halfway with
fresh water and then replace. The display shows
PRESS STEAM.
12. Place a large container under the steam nozzle (Fig. 4).
13. Push either steam button. The display shows
MACHINE
DE-SCALING. For 2 minutes, it will pump fresh water in
intervals through the steam nozzle into the container
underneath. Then machine "beeps". The display shows
OPEN TAP.
29.