Filter
Top Products
Monetary Setup HDC II Programming Guide
6730018 15 July, 2003
SELECT CARD READER
1. Press , then press until the current card reader is shown in
the display. Press to choose the desired card reader.
2. Your choices are: , , or .
3. Proceed to SELECT MONETARY OPTIONS, page 15, to customize
your card reader choice.
NOTE
Depending upon your choice of card reader, some displays
may not appear.
4. CONTINUE.
SELECT MONETARY OPTIONS
Certain options can be selected, depending upon which monetary devices you
have selected.
This function lets you:
1. Press , then press until the display shows .
represents the largest denomination coin or bill that will be changed
without a purchase. Any non-zero value here will return all escrowed coins.
(Each coin denomination for which the coin mech has a tube is called an
ESCROWED coin because it can be returned.) When the coin return button
is pressed, all coins inserted will be returned provided there is a coin mech
tube for each of those coins, EXCEPT in the forced vend mode.
Some examples:
- Forced vend; NO change returned without a purchase.
- Returns change without purchase if all accepted coins are
less than .25 denomination or have a payout tube. Accep
-
tance of a dollar coin will not cause a Force Vend if the
coin mechanism has a dollar coin payout tube. Otherwise,
accepting a dollar coin or accepting and stacking of a dol
-
lar bill will cause a Force Vend.
- Bills and non-escrowed coins less than or equal to $1.00
will be changed without purchase. All escrowed coins
are returned.
• Set change returning criteria
• Set declining balance
• Set currency acceptance on low
change
• Set overbuy options
• Set last bill stacking options
• Set card reader revalue options