Filter
Top Products
CONNECTING THE BEVERAGE DISPENSER
Preparing A Standard 5 Liter Mini Keg
10
USING THE YELLOW ADAPTOR
To connect the Yellow Adapter to a standard 5 liter mini
keg, follow these instructions.
NOTE: MAKE SURE ALL COMPONENTS ARE
PROPERLY SANITIZED PRIOR TO EACH USE.
PREPARING THE STANDARD 5 LITER MINI KEG
1. Screw the YELLOW RISING PIPE into the YELLOW
ADAPTER. Make sure there is an o-ring inside the RISING
PIPE. (See
Figure 2
)
2. Remove the plug from the top of the keg tap to ventilate
the keg. This releases the pressure build-up in the top of the
keg. The ventilation openings are designed differently per keg
type. Check the top ventilation opening to make sure the
opening is wide enough for the YELLOW RISING PIPE. If
there are parts in the way, such as a plastic edging, make
sure it is removed. It may be necessary to use a screwdriver
or pliers to do so.
3. Insert the YELLOW RISING PIPE (attached to the
YELLOW ADAPTER) into the top ventilation opening of the
mini keg. (See
Figure 3
)
4. If the YELLOW RISING PIPE does not fit into the tap, you
may be required to remove the plastic seal completely from
the ventilation tap using pliers. If this is required, insert the
provided BLACK RUBBER SEAL (See “
Parts & Accessories”
on page 7) into the keg before inserting the RISING PIPE.
This will create a tight seal between the keg and the RISING
PIPE. Keep a cloth or towel on hand, as the beverage could
spill.
5. Make sure the YELLOW ADAPTER fits completely down on
top of the mini keg and the sides of the ADAPTER snap and
lock into place around the edges of the mini keg. (See
Figure
3
)
Figure 2
Figure 3
AIR IN
BEVERAGE
OUT
SIdes Snap &
Lock into
place around
edges
FASTEN
RISING PIPE
INTO WHITE
ADAPTER
(turn in
clockwise
Direction)