Filter
Top Products
r
i
A
r
i
A
CONNECTING THE BEVERAGE DISPENSER
12
Preparing A Standard 5 Liter Mini Keg (cont’d)
USING THE YELLOW ADAPTER (continued)
CONNECTING THE MINI KEG TO THE
DISPENSER
13. Insert the 5 liter mini keg (with the ADAPTER
connected)
into the dispenser. Insert the YELLOW MALE
CONNEC
TOR attached to the AIR-CONNECT TUBE into
the
AIR IN opening of the YELLOW ADAPTER
(See
Figure 6
). Make sure you hear a “locking click”
14
. Take the YELLOW MALE CONNECTOR attached to the
DISPENSING
TUBE and insert that end into the
BEVERAGE OUT opening of the YELLOW ADAPTER
(See
Figure 6
). Make sure you hear a “locking click”
15
. Make sure there are no kinks in the TUBES. There
needs
to be an even air flow from the unit to the keg and
even liquid flow from the keg to the tap. Also make sure the
keg is centered in the cooling compartment of the unit. This
ensures
even cooling throughout.
TURNING ON THE AIR PRESSURE
16. Before closing the lid of the dispenser, you need to turn
on
the air pressure which will generate the power to
dispense
the beverage.
17
. In the upper left hand corner of the under side of the
lid,
there is a black switch, labeled AIR ON or AIR OFF,
which
can be moved up or down. Move the switch to the
AIR ON position (See
Figure 7
). Once you close the lid the
power will be activated to turn the air pressure on.
18
. When the dispenser is not being used, make sure the
switch is in the AIR OFF position.
CLOSE THE LID
To turn on the power, please refer to “
Switching on the
Power
” on page 15
Figure 6
Figure
7
To connect dispensing tube to
Yellow adapter
PUSH
UNTIL
LOCKING
CLICK
AIR ON/OFF
SWITCH
n