Danby DBD5L Beverage Dispenser User Manual


 
OPEN
CONNECTING THE BEVERAGE DISPENSER
Preparing A Standard 5 Liter Mini Keg (cont’d)
USING THE YELLOW ADAPTER (continued)
DISPENSING TUBE FOR YELLOW ADAPTER
The DISPENSING TUBE will be pre-assembled, but if
assembling is required please follow these instructions:
DISPENSING TUBE WITH BLACK STOPPER
YELLOW MALE CONNECTOR
METAL CLIP
8. Place the CLIP over the end of the DISPENSING TUBE
9. Insert the YELLOW MALE CONNECTOR into the
opening of the end with the CLIP. Attach the CLIP so it
seals the MALE CONNECTOR into place under the TUBE.
(See
Figure 4
)
10. When finished, take the other end of the DISPENSING
TUBE (the side with nothing attached) and insert it into the
opening of the tap. (See
Figure 5
)
11. Pull the TAP HANDLE down so the DISPENSING TUBE
fits through the tap. To do this, you may have to push and
thread it through. Make sure the BLACK STOPPER fits
securely in the inlet just before entering the tap.
(See
Figure 5
)
12. The DISPENSING TUBE needs to go all the way
through the spout. The TUBE should be slightly exposed
below the bottom of the tap. (See
Figure 5
)
11
Figure 4
Figure 5
BLACK STOPPER
TUBE IS
EXPOSED
YELLOW MALE CONNECTOR
DISPENSING TUBE
Attach METAL CLIP so it seals
MALE CONNECTOR in place