Filter
Top Products
17
OPERATING THE BEVERAGE DISPENSER
Depressurize To Disconnect the Mini Keg & the Container
YELLOW ADAPTER - First, pull out the MALE CONNECTOR
attached
to the AIR-CONNECT TUBE from the ADAPTER, then pull
out
the MALE CONNECTOR attached to the DISPENSING TUBE
from
the ADAPTER. Then, push down on the metal press tabs (See
Figure 19
).
WHITE BEVERAGE CONTAINER ADAPTER- Pull the DISPENSING TUBE off of the DRINK OUT
pipe
of the ADAPTER. Then, pull off the AIR-CONNECT TUBE from the AIR IN pipe of the
ADAPTER. It may be necessary to pull hard.
5. Once the TUBES have been disconnected from the ADAPTERS, pull the tap handle toward you.
Dispense
any unnecessary liquid from the DISPENSING TUBE, then pull the TUBE out of the tap.
6. Gently release the tap handle back to its resting position.
7. Remove the mini keg or container from the beverage dispenser.
8. To disconnect the ADAPTERS:
YELL
OW ADAPTER: unclip the sides of the ADAPTER which cover the keg edges. Pull the
ADAPTER and the RISING TUBE out of the keg. Unscrew the RISING PIPE and the ADAPER.
WHIT
E BEVERAGE CONTAINER ADAPTER- push in the locking mechanisms on either side of the
ADAPTER and pull it off of the container. It may be necessary to pull firmly due to air pressure
build-up. Pull out the RISING PIPE from the ADAPTER.
9. Thoroughly wash and clean the dispenser and all parts used.
NOTE: If you want to store the mini keg or container, see “
Shelf Life of Mini Kegs
” on page 16
Figure 19
To disconnect
dispensing
tubes
PUSH
DOWN ON
ME
TAL
TAB
It is very important to depressurize the mini keg or container when you are finished using them. If the
pressure is not released, remaining high pressure could lead to spraying or spilling. Follow these
directions to ensure proper depressurization.
NOTE: 5 liter mini kegs are empty when only foam is being dispensed from the beverage dispenser. If
necessary you can also disconnect partially full mini kegs.
1. Switch OFF the dispenser.
2. To depressurize the keg or container, pull down the tap handle to dispense all additional beverage
which may be in the unit due to the pressure (ie. beverage that is in the RISING PIPE and ADAPTER).
When the dispensing beverage stops, gently release the tap back to its resting position.
3. Open the lid of the dispenser. If not already done, turn the air pressure switch to the AIR OFF position.
4. Disconnect the tubes while holding the adapter in place: