Filter
Top Products
16
Installation Instructions
WATER
CONNECTION
(cont)
1. Screw the faucet adapter onto (or into) the faucet tap. Check for leaks (use
Teflon tape to eliminate if necessary).
2. Connect the six-sided connection of the drain hose to the drain port connection
on the back of the dishwasher cabinet. Do not over-tighten (to avoid damage to
threads.)
3. Connect the star-shaped connection of the inlet hose to the inlet port on the
back of the dishwasher cabinet. Do not over-tighten (to avoid damage to threads.)
4. Connect the circular connection of the drain hose onto the longer (bottom) male
connection on the quick connect.
5. Connect the circular connection of the inlet hose onto the shorter (top) male
connection on the quick connect.
6. Attach the quick connect onto the faucet adapter, by pulling down the outer
locking collar on the quick connect, while pushing the quick connect upward onto
the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking col-
lar. Verify the connection is secure.
8. Slowly open the hot water line and check for any sign of water leaks at all hose
connections. If leaks are located, immediately turn off the water supply and repair
the hose connections.
IMPORTANT
1. Once you open the water supply line, (even if it is closed immediately
thereafter), the inlet hose will be pressurized.
2. To relieve water pressure from inside the inlet hose, first make sure the
water line (faucet) is closed, then press and hold the red pressure relief
button on the quick connect until the flow of water stops.
WARNING
Failure to relieve water pressure before disconnecting the quick connect
from the faucet will result in back pressure over-spray.
The temperature of the incoming water can be very hot and can cause
severe burns and/or scalding.
DANGER
Do not let children disconnect the dishwasher. Close supervision of chil-
dren is always important around appliances.
NOTE: Hard water conditions will adversely affect the washing performance of
your dishwasher. Hard water conditions will also contribute to 'lime' (white film
substance) deposits and/or 'scaling' on the stainless steel surface of the dishwash-
er tub and heater element, located in the sump underneath the removable filter
screen. To minimize these conditions, it is recommended to operate/rinse the
inside of the dishwasher (empty) using 1 cup of white vinegar once a week.
DISCONNECTING YOUR DISHWASHER
1. Shut off the water supply at the faucet.
2. Disconnect the power supply cord
3. Relieve water pressure
4. Pull down on the quick connect collar