8
INSTRUCTIONS
Read these instructions carefully before using the appliance.
• Failuretorespecttheseinstructionsmayresultinburnsor
damage to the appliance.
The manufacturer is not liable for damage deriving from
failure to respect these instructions.
Please note:
Keep theseinstructions. Ifthe applianceis passed to other
persons, they must also be provided with these instructions.
DESCRIPTION
Description of the appliance
(page 3 - A )
A1. Grinding adjustment knob
A2. Main switch
A3. Beans container
A4. Beans container lid
A5. Cover for funnel and measure compartment
A6. Measure compartment
A7. Cup shelf (cup warmer enabled from settings menu)
A8. Pre-ground coee funnel
A9. Steam spout
A10. Cappuccino maker (removable)
A11. Cappuccino/hot milk selection ring
A12. Steam nozzle (removable)
A13. Water tank
A14. Power cable
A15. Cup tray
A16. Drip tray
A17. Service door
A18. Grounds tray
A19. Coee spout (adjustable height)
A20. Coee guide
A21. Infuser
A22. Control panel
Description of control panel
(page 3 - B )
A number of buttons on the panel have a dual function. This is
indicated in brackets in the description.
B1. Display: guides the user in using the appliance.
B2. Steam/hot water knob
B3. button: to deliver two cups of coee (When
you access the MENU: to change menu items and
parameters)
B4. button: to make 1 cup of coee (When you access
the MENU: OK to conrm menu parameters)
B5. MENU button: to access the settings menu.
B6. button: to turn the appliance on and o (stand-
by)
B7. button: to select the steam function.
B8. LONG button: to deliver one cup of LONG coee.
B9. button: to select coee quantity (When
you access the MENU: to change menu items and
parameters)
B10. button: to select coee taste (When you access
the MENU: ESC to exit the menu)
B11. button: to perform a rinse cycle
B12. button: to make 1 cup using pre-ground
coee
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the product is
complete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged. Contact
De’Longhi Customer Services.
Installing the appliance
Important!
When you install the appliance, you should respect the
following safety warnings:
• The appliance gives o heat. After positioning the
appliance on the worktop, leave a space of at least 3 cm
between the surfaces of the appliance and the side and
rear walls and at least 15 cm above the coee maker.
• Waterpenetratingtheappliancecouldcausedamage.Do
not place the appliance near taps or sinks.
• Theappliancecouldbedamagedifthewateritcontains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
• Arrangethepowercableinsuchawaythatitcannotbe
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connecttheappliancetoanecientlyearthedandcorrectly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Using the appliance for the rst time
Please note :
• Coeehasbeenusedtofactorytesttheapplianceanditis
therefore completely normal for there to be traces of coee
in the grinder. The machine is, however, guaranteed to be
new.
• Youshouldcustomisewaterhardnessassoonaspossible
following the instructions in the section “Setting water
hardness” on page 16.
1. Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(g. 1).