Filter
Top Products
15
The drip tray is tted with a level indicator (red) showing the
level of water it contains (g. 24).
Before the indicator protrudes from the cup tray, the drip tray
must be emptied and cleaned.
To remove the drip tray:
1. Open the service door (g. 23);
2. Remove the drip tray and the grounds container (g. 25);
3. Empty the drip tray and grounds container (A18) and
wash them;
4. Replace the drip tray complete with grounds container;
5. Close the service door.
Cleaning the inside of the machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned
o (see “Turning o”) and unplugged from the mains power
supply. Never immerse the coee maker in water.
1. Check regularly (about every 100 coees) that the inside
of the appliance (accessible after removing the drip tray)
is not dirty. If necessary, remove coee deposits with the
brush or a sponge.
2. Remove the residues with a vacuum cleaner (g. 26).
Cleaning the water tank
1. Clean the water tank (A13) regularly (about once a month)
with a damp cloth and a little mild washing up liquid.
2. Clean to remove all washing up liquid residues, then rinse
the water tank thoroughly.
Cleaning the coee spouts
1. Clean the coee spouts with a sponge or cloth (g. 27).
2. Check the holes in the coee spout are not blocked. If
necessary, remove coee deposits with a toothpick (g.
28).
Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground
coee funnel (A8) is not blocked.
If necessary, remove coee deposits with a brush.
Cleaning the infuser
The infuser (A12) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see Turning
o).
2. Open the service door (g. 23).
3. Extract the drip tray and the grounds container (g. 25).
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (g. 29).
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID NO DISH WASHER
Do not use washing up liquid to clean the infuser as it could
cause damage.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. After cleaning, replace the infuser by sliding it onto the
internal support and pin at the bottom, then push the
PUSH symbol fully in until it clicks into place.
Please note!
Iftheinfuserisdiculttoinsert,
you must rst adapt it to the right
dimensions by pressing it
forcefully from the bottom and
top as shown in the gure.
7. Once inserted, make sure the two red
buttons have snapped out.
8. Replace the drip tray and waste coee
container.
9. Close the service door.
DESCALING
Descale the machine when the message “DESCALE” ashes on
the display.
Important!
Descaler contains acids which may irritate the skin and eyes.
It is vital to respect the manufacturer’s safety warnings given on
the descaler pack and the warnings relating to the procedure to
follow in the event of contact with the skin and eyes.
Please note!
Use De’Longhi descaler only. Under no circumstances should
you use sulphamic or acetic based descalers. Their use
invalidates the guarantee. Failure to descale the appliance as
described above also invalidates the guarantee.